Jenn-Air PRG3010 series Service

WARNING! To avoid risk of electrical shock, personal injury or death;disconnect power to unit before servicing.Disassembly Procedures20 16022882 Rev. 0 ©2004 Maytag ServicesDual Feed Burner BaseNOTE: Maintop needs to be removed for burner basereplacement.1. Disconnect power and shut off gas supply to unit.2. Remove maintop, see “Maintop” procedure.3. Remove gas lines from burner base.4. Remove screw securing ground wire, located at thefront of the burner hanger.5. Remove screw securing front baffle to burner hanger.6. Trace high voltage electrode wire to spark module anddisconnect.7. Pull electrode wire through front baffle.8. Remove dual feed burner base off of hanger, byremoving screws from the bottom of the hanger.9. Reverse procedure to reassemble.Broil BurnerNOTE: Unit must be pulled away from the wall for thisprocedure.1. Disconnect power supply to unit.2. Remove oven door, see “Oven Door” procedure.3. Remove screws securing broiler ignitor bracket to theback wall of the oven cavity.4. Gently lower the ignitor down and let hang freely.5. Remove gas line from venturi using a 5/16” wrench.6. Remove screws securing broil burner to the ovencavity top.NOTE: When removing burner, ensure the burner will notfall or come down at an angle.NOTE: Use caution not to damage orifice elbow andinsulation.Convection Fan / Capacitor1. Disconnect power supply to unit.2. Remove oven door, see “Oven Door” procedure.3. Remove bake element, see “Bake Element”procedure.4. Remove screws securing convection baffle to rear ofoven cavity.5. Remove screws securing convection fan to rear of ovencavity.NOTE: When removing the last two screws, hold fanassembly in place.6. Gently lower fan and place on the oven bottom.7. Disconnect and label wire terminals on fan.NOTE: When reinstalling, install screws into centerholes on convection fan to assist in aligningcorner holes.8. Replacement of capacitor can be done two ways.• Removal of convection fan.• Accessing through the rear of the unit and removingthe rear motor housing.9. Reverse procedure to reassemble.Gas Train1. Disconnect power and shut off gas supply to unit.2. Remove maintop, see “Maintop” procedure.3. Remove screws securing kick plate at each topcorner.4. Remove screws securing regulator and gas trainbrackets in place.5. Disconnect gas line from regulator.6. Disconnect gas line at top of unit going to manifold.7. Remove gas train from unit.8. Reverse procedure to reassemble.Door Latch1. Disconnect power supply to unit.2. Remove screws securing latch cover.3. Remove screws on far sides of latch plate.4. Slide latch assembly out of unit chassis5. Disconnect and label wire terminals on latchassembly.6. Reverse procedure to reassemble.Control Box1. Disconnect power supply to unit.2. Remove screws securing kick plate at each topcorner.3. Remove screws securing control box to unit chassis.4. Carefully slide control box out, to gain access torelays.NOTE: On replacement of any components in thecontrol box, verify proper wire location.5. Reverse procedure to reassemble.High Temperature CutoutNOTE: High Temperature Cutout is located in the centerof the unit, underside of the oven cavity.1. Reset the switch when needed by pressing in buttonon bottom of switch.2. Switch can be replaced, by removing screws,detaching wires, and replacing.