Jenn-Air W10253462A User Manual

114. Position blower motor in cabinet opening. Connect ventsystem to blower motor outlet using a vent clamp.5. Mount blower motor to the floor with 4 - #8 x ¾" hex headscrews provided.6. Go to the “Electrical Connection” section.Floor Venting1. Mark the floor at the center of the cabinet opening.2. Position template on floor by matching the centerline of thetemplate to the centerline drawn on the floor and placetemplate 2¼" (5.7 cm) from the back wall.3. Determine the correct position for the vent hole, dependingon obstructions (joists) in the floor.The hole can be cut anywhere within the boundaries of eitherhatched area.Option 1: If you are using the back hatched area (bigger one),the blower inlet must face the left side as shown on thetemplateOption 2: If you are using the front hatched area (smaller one),the blower inlet must face the back.NOTE: If the template is misplaced, the followingmeasurements can be used to determine the vent holelocation.Top ViewA. 18¾" (47.6 cm) maximum from backwall forward into cabinet openingB. InletC. Vent systemD. Vent clampE. Wall ventTop ViewABC DETop ViewOption 1 Option 2A. Inlet from rangeB. Exhaust outletTop ViewA. 9" (22.8 cm)B. 3¹⁄₈" (7.9 cm)C. 8³⁄₈" (21.3 cm)D. 6³⁄₈" (16.2 cm)E. 2¼" (5.7 cm)F. 12½" (31.7 cm)G. 18¾" (47.6 cm)H. 1½" (3.8 cm)I. 3½" (8.9 cm)AABBAB CDE FGHI