Jenn-Air W10253462A User Manual

192. Attach terminal lugs to line 1 (black), bare (green) ground, andline 2 (red) wires. Loosen (do not remove) the set screw on thefront of the terminal lug and insert exposed wire end throughbottom of terminal lugs. Securely tighten setscrew to torqueas shown in the following Bare Wire Torque Specificationschart.Bare Wire Torque SpecificationsAttaching terminal lugs to the terminal block - 20 lbs-in. (2.3 N-m)3. Use ³⁄₈" nut driver to connect the bare (green) ground wire tothe center terminal block post with one of the 10–32 hex nuts.4. Connect line 1 (black) and line 2 (red) wires to the outerterminal block posts with 10-32 hex nuts.5. Securely tighten hex nuts.6. Replace terminal block access cover.A. Terminal lugB. SetscrewC. Line 1 (black) wireD. Bare (green) groundwireE. Line 2 (red) wireABC D EWire Awg Torque8 gauge copper 25 lbs-in. (2.8 N-m)6 gauge aluminum 35 lbs-in. (4.0 N-m)A. 10–32 hex nutB. Line 1 (black)C. Ground-link screwD. Bare (green) ground wireE. Line 2 (red)F. Terminal lugBFAEDC