Jenn-Air W10253462A User Manual

20Connect Range to Downdraft System1. Attach flexible vent (provided) to the blower motor inlet usinga vent clamp.2. Check countertop height to allow range top to clearcountertop. Adjusting leveling legs if necessary.3. Remove access panel by grasping both sides, pullingupward, and lifting out.4. Move range close to cabinet opening.5. Plug range into grounded outlet (if using a power supplycord).6. Plug range electrical connector into the downdraft blowermotor.7. Remove cardboard or hardboard from under the range. Using2 or more people, gently move range into its final location.8. Check that the anti-tip bracket is installed and that electricalcords are not kinked. Use a flashlight to look underneath thebottom of the range.■ Look for the anti-tip bracket securely attached to floor orwall.■ Slide range back so rear range foot is under anti-tipbracket.9. Level the range.a.) Place rack in oven.b.) Place level on rack and check levelness of the range, firstside to side; then front to back.c.) If range is not level, pull range forward until rear levelingleg is removed from the anti-tip bracket.d.) Use a wrench or pliers to adjust leveling legs up or downuntil range is level.e.) Push range back into position.f.) Check that rear leveling leg is engaged in anti-tip bracket.NOTE: Range must be level for satisfactory baking performance.A. Inlet flexible ventB. Vent clampA. Power supply cord (on some installations)B. Range electrical connector to blower motor121ABAB