2013.0 Troubleshooting the JDP-17Table 3Trouble Probable Cause RemedyDrill press will not start(power light is OFF).Not connected to power. Check plug connection.Fuse blown, or circuit breaker tripped. Replace fuse, or reset circuit breaker.Cord damaged. Replace cord.Drill press will not start(power light is ON).Safety key removed. Install safety key.Switch malfunction. Have switch tested and replaced ifneeded.Drill press does notcome up to speed.Extension cord too light or too long. Replace with adequate size and lengthcord.Low current. Contact a qualified electrician.Motor or spindle pulley out of balance. Contact JET technical service.Motor malfunction.Have motor tested by a qualifiedservice center. Repair or replace asnecessary.Motor stalls.Overfeeding the bit. Lower bit more slowly.Dull bit. Sharpen or replace bit.Motor not reaching running speed. Have motor tested by a qualifiedservice center.Motor malfunction.Have motor tested by a qualifiedservice center. Repair or replace asnecessary.Noisy Operation.Excessive vibration.Tighten any loose parts. Drill pressshould sit evenly on level floor. Securedrill press to floor or plywood base.Dry spindle. Lubricate spindle.Loose pulleys or belts. Make any needed corrections. Verifythat belts are properly tensioned.Noisy motor. Check motor bearings or for loosemotor fan.Wood splinters onunderside of workpiece.No backing board used. Place scrap board beneath work pieceto prevent splintering.Drill or tool heats up orburns work piece.Excessive speed. Reduce speed.Chips not clearing from hole or bit. Retract drill bit frequently to removechips.Dull drill bit. Resharpen, or replace drill bit.Feeding bit too slowly. Increase feed rate.Drill bit wanders.Bit sharpened incorrectly. Resharpen bit correctly.Bent drill bit. Replace bit.Bit or chuck not installed properly. Reinstall chuck or bit.Drill bit binds in workpiece.Work piece pinching the bit. Support or clamp work piece.Excessive feed rate. Lower bit more slowly into workpiece.Speed setting too low for workpiece. Consult chart for recommended speed.Chuck jaws not tight. Tighten chuck jaws.Chuck won’t remain inspindle.Grease or dirt on spindle or chucktapers.Clean tapers thoroughly.14.0 Replacement PartsReplacement parts are listed on the following pages. To order parts or reach our service department, call 1-800-274-6848 Monday through Friday, 8:00 a.m. to 5:00 p.m. CST. Having the Model Number and SerialNumber of your machine available when you call will allow us to serve you quickly and accurately.