Jet JWDP-12 Operating Instructions And Parts Manual

Contents

76.0 Assembly6.1 Base and column assemblyRefer to Figure 3:1. Place base (D) on a level floor.2. Place column assembly (E) on base (D) and alignholes in column support with holes in base.3. Using a 5/8-in wrench, secure column (E) withfour M10 x 25 hex cap screws (N) to the base.6.2 Table and rackRefer to Figure 4:Note: If table arm/support assembly (C) and rack (E 3 )are already installed on column (E), proceed to step 4.Otherwise, begin with step 1.1. Remove rack ring (E 1 ) and rack (E3 ) from column(E). Note which end of the rack is up. It must bereinstalled later with the same side up.2. Place rack (E 3 ) inside table support (C) such thatthe teeth of the rack (E 3 ) mesh with the piniongear on the end of the table crank handle shaft(C 1 ).3. Slide table arm/support assembly (C) togetherwith the rack (E 3 ) onto the column (E) as shown.4. Place rack ring (E 1 ) onto column (E), sliding itdown so it rests against rack (E 3 ) as shown, andtighten setscrew (E 2 ) with a 3mm hex wrench(provided).5. Place table (B) onto table arm (C), positioning itas shown in Figure 4. Secure table with lockhandle (K).6. Secure table extension (B 1) with two tableextension lock knobs (Q).6.3 Table height adjust and lockhandlesRefer to Figure 4:1. Loosen the setscrew (R 1) on the table heightadjust handle (R).2. Slide the handle (R) onto the table bracket shaft (C1).3. Turn the handle (R) until the setscrew (R 1) is onthe flat section of the shaft (C 1) and tighten thesetscrew (R 1) with a 3mm hex wrench to securethe handle.4. Thread the column lock handle (K) into the backside of the table bracket (C) opposite the heightadjust handle (R).Figure 3Figure 4