CB/FCB-BA-e-0640147.2 WeighingSwitch on the balance using the key.The balance shows for approx. 3 seconds „88888“ in the display and then goes to„0“. Now it is ready for operation.Important: Should the display flash or not be on „0“, press the key.Only now (!) place goods onto weighing plate. Take care that the weighed materialdoes not touch the balance housing or the base mat.Now the weight is displayed, after the standstill control appears the weighing unit(e.g. g or kg) right-hand in the display.If the goods are heavier than the weighing range, the display will show "Error"(=Overload), and a whistle is sounded.7.3 TaringSwitch-on the balance using the key and wait for the „0“ display.Place the tare vessel on the weighing plate and press the key. Thebalance display goes to „0“. The weight of the container is now internally saved.If after finishing the weighing process the key is pressed again, „0“appears anew in the display.The taring process can be repeated any number of times, e.g. when adding severalcomponents for a mixture (adding).The limit is reached when the whole weighing range is exhausted.After removing the taring container the total weight is displayed as negative display.7.4 PRE-Tare functionUsing this function the weight of a tare vessel can be stored.This value also remains saved if the balance meanwhile has been switched off andswitched on again.For this switch on the balance using the key and wait for the „0“ display.Put tare vessel on the weighing plate and press the key 6 times until „PtArE“flashes on the display. By actuating the key, the current weight on the weighingplate is saved as PRE-Tare weight.To switch off this function unload the weighing plate and press the key6 times, until „PtArE“ flashes on the display. After that press the key. The storedPRE-Tare weight is deleted.