PES/PEJ-BA-defsi-0510 141There are two different ways to set the tolerance limits:1. Place the values (object) on the balance -> Save this value2. Numeric entering of values -> Enter the limits via keyboard.NOTE:If a limiting value was set it remains saved until the balance is turned off.For the functions weighing, counting, percent individual limits can be set.When entering the limits please pay attention to the type of evaluation that was set.12.2. Display of the results12.2.1. For 2 limitsThe triangular tolerance marker ( ) in the upper part of the display shows whetherthe goods to be weighed are within the two tolerance limits.The tolerance marker is only in operation during operating mode tolerance weighing;it is otherwise not visible.The tolerance marker provides the following information:Goods to be weighed above tolerance limitGoods to be weighed within tolerance rangeGoods to be weighed below tolerance limitDisplayResultIf a point is set as lowerlimitIf two points are set as upper andlower limit+ (high) No display Weight > Upper limitTOL (OK) Lower limit Weight Lower limit Weight Upper limit- (low) Lower limit > Weight Lower limit > Weight