Kenwood CS-5140 Instruction Manual

M A I N T E N A N C EREPLACING T H E F U S EIn case the fuse has blown, locate the cause. If the fuseitself is the cause, replace it as follows:1 . Pull the plug of the power cord from the power outlet.2 . Remove the fuse holder in the rear panel using a stan-dard screwdriver (see Fig. 4 3 ) .3 . Take out the blown f u s e , and in its place, insert a newfuse.4 . Set the label of your line voltage to the mark • , thenplug the fuse holder containing the new fuse into therear panel.CHANGING THE SUPPLY VOLTAGERemove the fuse holder in the rear panel using a standardscrewdriver. Then set the label of your line voltage to themark • and plug the fuse holder back into place. Whenchanging the supply setting from 1 0 0 / 1 2 0 V to2 2 0 / 2 4 0 V , change the 1.2 A fuse for a 0 . 8 A one. (seeFig. 4 3 )Fig. 4 331Fuse holder