Kenwood CS-5140 Instruction Manual

RESETTING T H E R E A D O U T C A L E N D A R ANDC L O C K D I S P L A YT h e readout calendar and clock display can be changed andreset with the D A T E change switch located on the rightend of the rear side on the bottom. (This can be performedwithout removing the case.)NOTE: When performing the following operations, be sureto use an insulated stick.CD ON/OFFThis switches the calendar and clock display on andoff. When switched on, the display will appear on theC R T , and will go out when switched off.(2) S E L E C TThis is used to select the section of the calendar andclock display to be corrected. When this button ispressed, correction mode is activated and the" m o n t h " indication will blink. Pressing the buttonagain will move the blinking position to the 1 0 ' s col-umn, for the " d a t e " indication. In this w a y , each timethe button is pressed, the blinking position is shifted tothe right one column sequentially. Once the blinkingposition reaches the " m i n u t e s " indication and the but-ton is pressed again, all indications will be lit steadily toshow that correction mode has finished.NOTE: During correction mode (when there is a blink-ing section within the calendar or clockdisplay), w h e n the control knobs on the frontpanel are operated, a correct readout displaywill not be obtained. Be sure to complete cor-rection mode before operating the controlknobs.(3) This is used to correct the calendar and clock display.When this button is pressed, the blinking figure subjectto correction is changed. Press the button to set thecalendar or clock display as desired. The " m i n u t e s " in-dicator will be set to "0" when the correction mode isreleased.Bottom of the caseFig. 4 432