Kenwood DDX8034BT Instruction Manual

Also see for DDX8034BT: Instruction manual Installation manual Instruction manual

Contents

Kenwood DDX8034BT Instruction Manual Manual pdf 101 page image

English 101Help? ErrorWhen the unit fails to operate correctly, thecause of the failure appears on the display."Protect" :Protective circuit has been activated because a speakercord has shorted or it has come in contact with the carchassis.➡ Wire or insulate the speaker cord as appropriateand then push the Reset button."Hot Error" :When the internal temperature of this unit rises to 60°Cor more, the protection circuit is activated and youmay not be able to operate the unit. At such times thismessage will appear.➡ Use the unit again after reducing thetemperature inside the vehicle."Mecha Error" :The disc player is malfunctioning.➡ Eject the disc and try inserting it again. Contactthe Kenwood dealer if this indicator continuesblinking or the disc cannot be ejected."Disc Error" :Disc is quite dirty.➡ Clean the disc, referring tot he section on (page 6).Disc is upside down.➡ Load the disc with the labeled side up.An unplayable disc is inserted."Region Code Error" :The disc you wanted to play has a region code thatcannot be played with this unit."Parental Level Error" :The disc you wanted to play has a higher level than theparental level you set."No Device" (USB device):The USB device is selected as a source although no USBdevice is connected.➡ Change the source to any source other than USB.Connect an USB device, and change the sourceto USB again."Disconnected" (iPod, Bluetooth audio player):The iPod/Bluetooth audio player is selected as a sourcealthough no iPod/Bluetooth audio player is connected.➡ Change the source to any source other thaniPod/Bluetooth. Connect an iPod/Bluetoothaudio player, and change the source to iPod/Bluetooth again."No Media File" :The connected USB device contains no playable audiofile.Media was played that doesn’t have data recorded thatthe unit can play."USB Device Error!!" :The connected USB device is rated a current capacityhigher than the allowable limit.➡ Check the USB device.Some trouble may have occurred to the connectedUSB device.➡ Change the source to any source other than USB.Remove the USB device."Not supported USB1.1 device." :The connected USB device is comliant with USB 1.1standard. This unit only supports the USB devicecomliant with USB 2.0 standard.➡ Use a USB device which this unit suppots."Authorization Error" :Connection to the iPod has failed.➡ Remove the iPod and then reconnect it.The unit does not support the iPod.➡ Refer to this unit> (page 8)."Update your iPod" :The iPod's software is an older version which the unitcan not support.➡ Confirm that the software for the iPod is thelatest version. Refer to connected to this unit> (page 8)."You only can connect one iPod." :More than one iPod are connected to this unit.➡ Connect only one iPod to the USB terminal withiPod tag.