Kenwood DMX5019DAB Instruction Manual

45ENGLISHREVERSEPRK SWInstallation and ConnectionInstallation and ConnectionWiring connection10 A fuseConnect the antenna cord to the aerial terminal.USB input terminals (1 m)Purple with white stripeLight blue with yellow stripeRed (Ignition wire)Red (A7)Yellow (Battery wire)Yellow (A4)Light greenTo the car’s reverse lamp harness when using the optional rear view cameraTo the remote adapter (not supplied) which is compatible with your car*1To the power control terminal when using the optional power amplifier (Or) To the aerial control terminal in the vehicle*1To the terminal that is grounded when either the telephone rings or during conversation.*1Extension parking cable ( ø )To the car’s parking brake detection switch harness(For best safety, be sure to connect the parking sensor.)Connector BConnector AConnecting the ISO connectorsYou may need to modify the wiring of the supplied wiringharness as illustrated below.Default wiringRed (A7)VehicleUnitRed(Ignition wire)Yellow (A4)Yellow(Battery wire)Pin Color and FunctionConnector A A4A5A6A7A8YellowBlue/White (output B)Orange/WhiteRedBlack: Battery: Power control: Dimmer: Ignition (ACC): Ground connectionConnector B B1/B2B3/B4B5/B6B7/B8Purple ] / Purple/Black [Gray ] / Gray/Black [White ] / White/Black [Green ] / Green/Black [: Right speaker (Rear/Tweeter*2): Right speaker (Front/Mid Range*2): Left speaker (Front/Mid Range*2): Left speaker (Rear/Tweeter*2)*1 If no connections are made, donot let the cable come out fromthe tab.*2 For 3-way speaker systemconnection, see page 44.Note: Total output for blue with whitestripe wires (output A + output B) is12 V 350 mA.Blue with white stripe (output A)BrownDAB aerial input jack: Connect theDAB aerial (separately purchased).