Kenwood DMX5019DAB Instruction Manual

50 ENGLISHMonitor sectionPicture Size (W × H) 6.2 inches (diagonal) wide137.5 mm × 77.2 mmDisplay System Transparent TN LCD panelDrive System TFT active matrix systemNumber of Pixels 1 152 000(800H × 480V × RGB)Effective Pixels 99.99%Pixel Arrangement RGB striped arrangementBack Lighting LEDSpecificationsSpecificationsUSB interface sectionUSB Standard USB 2.0 High SpeedCompatible Device Mass Storage ClassFile System FAT 16/FAT 32/NTFSMaximum PowerSupply CurrentDC 5 V 1.5 AD/A Converter 24 bitAudio Decoder MP3/WMA/AAC (.m4a)/WAV/FLACVideo Decoder MPEG1/MPEG2/MPEG4/H.264/WMV/MKVFrequencyResponse96 kHz Sampling:20 Hz to 20 000 Hz48 kHz Sampling:20 Hz to 20 000 Hz44.1 kHz Sampling:20 Hz to 20 000 HzTotal HarmonicDistortion0.020% (1 kHz)Signal to Noise Ratio 104 dBDynamic Range 90 dBThe unit does not respond when you try to copythe phonebook to the unit. You may have tried to copy the same entries (asstored) to the unit.“Connection Error” appears. The device is registered but the connection hasfailed. Connect the registered device. (Page 24)“Please Wait...” appears. The unit is preparing to use the Bluetooth function.If the message does not disappear, turn the poweroff and on, then connect the device again.“No Voice Device” appears. The connected mobile phone does not have avoice recognition system.“No Contents” appears. No phonebook data is contained in the connectedBluetooth phone.“Initialise Error” appears. The unit has failed to initialize the Bluetoothmodule. Try the operation again.“Dial Error” appears. Dialing has failed. Try the operation again.“Hung Up Error” appears. The call has not ended yet. Park your car, and usethe connected mobile phone to end the call.“Pick Up Error” appears. The unit has failed to receive a call.The Bluetooth connection between the Bluetoothdevice and the unit is unstable. Delete the unused registered Bluetooth devicefrom the unit. (Page 24)TroubleshootingTroubleshooting