Kenwood DPF-1010 Instruction Manual

Also see for DPF-1010: Service manual Service manual

Kenwood DPF-1010 Instruction Manual Manual pdf 21 page image

21DPF-3010/2010/1010 (En)Timer operationsTimer playback of CD can be started at any time using anaudio timer which is available in audio stores.Preparation ÷ Connect the power cords of the associatedcomponents so that their power can be turnedON through the audio timer.(Also, be sure to read carefully the instructionmanual of the timer.)This unitAudio cordSystem control cordAmplifierAudio timer To wall AC outlet1Turn the powers of the associated componentsON.2 PreparationLoad a disc in the CD player. @Set the amplifier volume.3 1 Play the disc.Set the timer ON time.4Set the timer so that it suppliespower at the specified time.Turn OFF the power output from the audio timer.5÷ With some audio timer models, the power is automatically turned OFFwhen the timer ON time is set. With such a model, skip step 5 below.Label side2 Adjust the amplifier volume.(Use the remote control unit of this unitto adjust the volume to the maximumlevel.)3 Stop the disc.÷ Do not touch the ON/STANDBY switches of the amplifier and CDplayer.÷ When the set time comes, the disc playback starts automatically.Adjusting the volume:Set the volume the maximum (0 dB) using the OUTPUT(UP) key on the remote control unit, and adjust the vol-ume to the desired level on the amplifier side.(Since the sound output is at the maximum level when thepower is turned on, lowering the level with the remote controlwill change the volume.)NotesNotes12F001 ¡47 6¢1¡476¢6PLAY/PAUSE7STOP1. Some amplifiers cannot be used with a timer. Before using a amplifier, check it.2. When operating the unit other than CD player using an audio timer, be sure to remove the disc from the CD player.NoteNoteNote÷ If the amplifier is not connected to the CD player through a systemcontrol cord, select the “CD” input with the input selector.

/ 24

Related manuals for Kenwood DPF-1010