Kenwood DPF-1010 Instruction Manual

Also see for DPF-1010: Service manual Service manual

Kenwood DPF-1010 Instruction Manual Manual pdf 9 page image

9DPF-3010/2010/1010 (En)Caution on disc usedCleaningIf fingerprints or foreign matter becomeattached to the disc, lightly wipe thedisc with a soft cotton cloth (or similar)from the center of the disc outwards,in a radial manner.StorageWhen a disc is not to be played for along period of time, remove it from theCD player and store it in its case.Label sideSticky pasteStickerNever play a cracked or warped disc.During playback, the disc rotates at high speed in the player.Therefore, to avoid danger, never use a cracked or deformed disc or adisc repaired with tape or adhesive agent.Do not use cleaning discs.Please do not use commercially available cleaning discs, they may dam-age the internal mechanism.MaintenanceDisc handling precautionsHandlingHold compact discs so that you do nottouch the playing surface.Be specially cautious against condensation in a following circumstance:When this unit is carried from a place to another across a largedifference in temperature, when the humidity in the room where thisunit is installed increases, etc.÷ Do not attach paper or tape to eitherthe playing side or the label side ofcompact discs.÷ The paste left on the label surface aftera sticker has been peeled off is a factorwhich may cause malfunction. If thesurface is sticky due to remaining paste,be sure to clean it with alcohole beforeuse.Discs which can be played with this unitCaution on condensationCondensation (of dew) may occur inside the unit when there is agreat difference in temperature between this unit and the outside.This unit may not function properly if condensation occurs. In thiscase, leave the unit for a few hours with the power left ON, andrestart the operation after the condensation has dried up.CD (12 cm, 8 cm), CDV (only the audio part)÷ With CD-G (CD Graphics) discs, this unit can play only the audio.Note related to transportation and movementBefore transporting or moving this unit, carry out the followingoperations.1. Turn the power ON but do not load a disc.2. Verify that the display shown appears.3. Wait a few seconds and set the unit to STANDBY mode.CleaningDo not use volatile solvents such as alcohol, paint thinner, gasoline,or benzine, etc. to clean the cabinet. Use a clean dry cloth.Do not use contact cleaners because it could cause a malfunction.Be specially careful against contact cleaners containing oil, for theymay deform the plastic components.CD accessoriesThe CD accessories (stebilizer, protection sheet, protection ring, etc.)which are marketed for improving the sound quality or protecting discsas well as the disc cleaner should not be used with this system be-cause they may cause malfunction.TRACK6111167212178313189414191051520n o d 1 S CPlayingside