Kenwood DPF-R3010 Instruction Manual

Also see for CD Series: Instruction manual Instruction manual

Kenwood DPF-R3010 Instruction Manual Manual pdf 23 page image

23CD-206/204/203/DPF-R6010/R4010/R3010 (En)Timer operationsTimer playback of CD can be started at any time using anaudio timer which is available in audio stores.1 Turn the powers of the associated componentsON.2 PreparationLoad a disc in the CD player. 9Set the amplifier volume.3 1 Play the disc.Set the timer ON time.4Set the timer so that it suppliespower at the specified time.Turn OFF the power output from the audiotimer.5÷ With some audio timer models, the power is automatically turned OFFwhen the timer ON time is set. With such a model, skip step 5 below.NotesNotes1. Some amplifiers cannot be used with a timer. Before using a amplifier, check it.2. When operating the unit other than CD player using an audio timer, be sure to remove the disc from the CD player.÷ If the amplifier is not connected to the CD player through a systemcontrol cord, select the "CD" input with the input selector.Preparation ÷ Connect the power cords of the associatedcomponents so that their power can beturned ON through the audio timer.(Also, be sure to read carefully the instruc-tion manual of the timer.)This unitSystem control cord Audio cordAmplifierAudio timer To wall AC outletLabel sideAdjusting the volume:Set the volume the maximum (0 dB) using the OUTPUT(UP) key on the remote control unit (Except CD-203/DPF-R3010) , and adjust the volume to the desired level on theamplifier side.(Since the sound output is at the maximum level when the poweris turned on, lowering the level with the remote control unit willchange the volume.)NoteNote÷ When the set time comes, the disc playback starts automatically.÷ Do not touch the ON/STANDBY (POWER/ ) switches of theamplifier and CD player.2 Adjust the amplifier volume.(Use the remote control unit (Except CD-203/DPF-R3010) of this unit to adjust thevolume to the maximum level.)3 Stop the disc.6712 : 00