5 Exit Audio Control modePress the [AUD] button for at least 1 second.• * This mode is available only when (page 30)is set on "N-F".• Refer to the catalog or instruction manual for power amplifiers thatcan be controlled from this unit.• For amplifiers there are the model that can be set from Flat to +18dB, and the model that can be set from Flat to +12 dB.When an amplifier that can only be set to +12 is connected to theunit, "Amp Bass +18" won't work correctly even if it's selected.1 Enter Audio Control modePress the [AUD] button."Audio CTRL" is displayed.2 Select the X’Over or Amp Control modePress the [AUD] button.Select the X’Over Control mode or Amp Control mode display.Each time the button is pressed the Balance/ Fader Controlmode, the X’Over Control mode and the Amp Control modeswitch.3 Select the X’Over or Amp Control item for adjustmentPress the [FM] or [AM] button.Each time the button is pressed the items that can be adjustedswitch as shown below.4 Adjust the Audio itemPress the [4] or [¢] button.X'Over control modeAdjustment Item Display RangeFront High Pass Filter "HPF-F" THRU/ 40/ 60/ 80/ 100/120/ 150/ 180/ 220 (Hz)Rear High Pass Filter "HPF-R" THRU/ 40/ 60/ 80/ 100/120/ 150/ 180/ 220 (Hz)Low Pass Filter* "LPF" 50/ 80/ 120/ THRU (Hz)Non-Fading level * "N-F" - - - — +10Non-Fading Phase * "N-F Phase" NOR (0°)/ REV (180°)Amp control modeAdjustment Item Display RangeBass boost level "Amp Bass" FLAT/ +6/ +12/ +18 (dB)Central frequency boost "Amp Freq" NML/ LowX’Over & Amp ControlGeneral features— 14 —EnglishYou can store into or recall from memory up to 3 X’Oversettings.1 Adjust the X’Over to put in the memoryRefer to (page 14).2 Put the X’Over setting in the memoryPress the [1] — [3] button for at least 2 seconds.The preset number display blinks 1 time.3 Exit Audio Control modePress the [AUD] button for at least 1 second.Recalling the X’Over setting1 Enter X’Over Control modeRefer to (page 14).2 Call up the X’Over settingPress the [1] — [3] button.3 Exit Audio Control modePress the [AUD] button for at least 1 second.Non-Fading level cannot be preset into the memory.X’Over Preset Memory
