18DVR-605/DVR-6100/DVR-6100K (EN)OperationsLet's put out some soundPreparation÷ set the POWER switch to the ON ( ) position.POWER-ON/–OFFPOWERINPUTSELECTORVOLUME CONTROLPOWERVOLUME MUTEINPUTPHONESBasic use methodSelecting the desired inputVolume adjustment12Muting the sound temporarilyListening through headphoneREMOTEREMOTEMAIN UNITTo decrease To increase To decreaseTo increaseRemote control unit only÷ Press again to resume the original volume.÷ The sound muting is also cancelled when the volume is con-trolled.÷ Press the MUTE key.Insert the headphone plug into the PHONES jack.÷ The sounds from all speakers are cut off.÷ When one of the keys on the left is pressed while STANDBYmode, the power will be switched on automatically and the inputwill be selected.÷ The power will be switched on and the respective operation willbe performed also when the OPEN/CLOSE key, the PLAY/PAUSE key or the BAND key on the main unit is pressed duringSTANDBY mode.÷ When a disc is set in the disc tray and the DVD CD key is pressed,disc playback will start automatically.In case of operation with the remote control unit, first selectthe input or device to be operated with the INPUT SELEC-TOR keys then perform the desired operation.The present mode of the remote control unit may notcoincide with the equipment to be operated.VOLUMEThis unit offers various surround modes, but it switchesautomatically to stereo mode when headphones are connected.To open the door, pull the lower part on the right side of themain unit.SATCABLEVCRTUNERBANDDVD/CDFRONTAUXINPUT+–VOLUMEMUTEPHONES1 Tuner (frequency display)2 VCR (VCR → ANALOG → VCR)3 SAT/CABLE (SAT/CABLE → AUTO → SAT/CABLE)4 FRONT AUX (FRONT → OPTICAL → FRONT)5 DVD/CDSwitching is done as follows when the INPUT key of themain unit is pressed. (The parenthesized part shows anoperating example.)The input mode can be switched with SAT/CABLEand FRONT AUX.Refer to “Changing the INPUT MODE” YNoteNoteMAIN UNITMAIN UNITNormally "MAX" is displayed when the volume settings set tothe maximum value.If you have adjusted the speaker level above 0 db with the TRIMkey (R), "MAX" will not be displayed.÷ When using the remote to select SAT or CABLE;SAT (SAT → AUTO → SAT)CABLE (CABLE → AUTO → CABLE)