Kenwood KDC-5018 Instruction Manual

Also see for KDC-5018: Service manual

Kenwood KDC-5018 Instruction Manual Manual pdf 27 page image

If you have preset the name of a disc that you want to listen toin the disc changer, you can look for it by name and startplaying it.Press the DNPP button on the remote."DNPP" will appear in the display, and the disc name presetplay mode is entered.The preset names/disc titles of the disc in the disc changer towhich you are currently listening are successively displayed forfive seconds each.In any of the units that are connected, discs that have notbeen disc name preset will display "NO NAME".• This function can only be used in disc changers that weremanufactured or sold as of 1997. Also note that some unitscannot provide a display unless the disc name preset has beenmade by the unit that is playing.• Discs in the disc changer that have never been played beforewill appear as "NO ACCESS" when the disc names aredisplayed. When you cannot identify a disc because of the "NOACCESS" display after inserting a disc magazine, try playing it todisplay the disc name. Also note that "NO DISC" will bedisplayed when a disc has not been loaded.Rapid display (forward / reverse):Press the DISC + or DISC – button.Pressing the DISC + button will rapidly display the presetnames/disc titles in order.Pressing the DISC – button will rapidly display the presetnames/disc titles in reverse order.When the name appears for the disc you want to playPress the OK button.The disc whose name is displayed will be recalled, and the discname preset play (DNPP) mode will end.To cancel DNPP mode:Press the DNPP button.The disc name preset play (DNPP) mode will be canceled.2NOTE1Disc Name Preset Play (DNPP)(Function of Remote)Continue steps 3 and 4 until all the characters are chosen forthe name.You can enter up to 12 characters for each name.Press the NAME.S button.The disc name is stored and the disc name preset mode iscanceled.If you make no entry in a 10-second period, the name will bestored with the characters input so far.• The number of discs whose names can be stored will differdepending on the disc changer that is connected. Please seeyour disc changer manual for details.Up to 30 CDs can be registered with this unit.• Discs are identified by their total length and number of tracks. Ifanother disc happens to have the same specifications as onethat you have already stored a name for, the name will bedisplayed for it, too.• If you want to change the name of a disc, repeat steps 1 and 2to display the name, and then repeat steps 3 and 4 to input thechanges.• Pressing the reset button erases the disc names stored in thisunit, but does not erase the names stored in a disc changer.NOTE6NOTE5Alphabet (upper case): A ~ ZAlphabet (lower case): a ~ zNumerals and symbols: 0~9 @ ” ‘ ` % & ∗ + - = , . / \ < > [ ]Special characters: á à é è í ì ó ò ú ù Ñ Ç ® ß ‹ fl â ä êë î ï ô ö û ü ñ ç © Æ › fi— 27 —