Kenwood KDC-5018 Instruction Manual

Also see for KDC-5018: Service manual

Kenwood KDC-5018 Instruction Manual Manual pdf 29 page image

This function produces a beep sound that accompanies buttonoperation. It can be switched on or off.Display and setting:"Beep ON" : Beep setting is on. (Default setting)"Beep OFF" : Beep setting is off.The beep sound is not output from the preout jacks.NOTETouch Sensor Tone"ENTER" and "CODE" will appear in the display, asking you toinput the code.If you input an incorrect security code, the code setting modewill be canceled automatically. Follow the steps from 3 to 7above again.If you press the RESET button or remove the battery:The first time you turn the unit on again, "CODE" will appear inthe display, asking you to input the security code.Repeat steps 6 and 7 above, and input the security code.You can start operating the unit again when "APPROVED"appears in the display.If you enter the wrong code, "Waiting" is displayed and youcannot make further input of the code for a fixed interval (seetable below), which grows longer each time you enter the wrongcode.When "CODE" is displayed, you can make input again.The number of wrong inputs is displayed.Number of wronginputsInterval until next inputis allowed1 -2 5 minutes3 1 hour4 24 hoursNOTENOTEbefore the security code function can be turned on. However,once the procedure is finished, it need not be repeated.Once the security code function has been activated, "Security"disappears from the MENU system. Note that it will no longer bepossible to cancel this function afterwards.Press the SRC button repeatedly to select the standby mode."ALL OFF" is displayed when the standby mode is selected.Press the MENU button for at least one second."MENU" is displayed first and then "Security" is displayed.Press either the 4 or ¢ button for at least two seconds."ENTER" will appear in the display for one second, indicatingthe code setting mode has been entered. When "CODE"appears in the display, you can start inputting the code.Press the preset button and enter your security code.Use the security code shown on your Car Audio Passport.Example: Enter "3510" as your code, pressing the buttons asfollows:Press the DISP button for at least three seconds.The security code will be set."RE-ENTER" will appear in the display for one second, askingyou to enter the code once again for confirmation. When"CODE" appears in the display, you can start inputting thecode.Press the Preset button and input the security code again.Press the DISP button again for at least three seconds."APPROVED" will appear in the display, with the security codefunction turning on. From this point on, if the unit isdisconnected from the battery, the security code must beentered the first time that the unit's power is turned on.765Step Button to press # Timespressed Display1 #1 436#22#3 24 #4 1“3”“5”“1”“0”4321— 29 —