46 | KDC-BT60U/ KDC-6047UBluetooth SetupBluetooth SettingYou can select following Bluetooth Setting items.1 Enter Bluetooth modeKDC-BT60UPress the [ ] button.KDC-6047UPress the [TI] button for at least 1 second.✍ You can also select from “Settings” in Menu Listmode.2 Turn the [VOL] knob and press it when thedesired item is displayed.Select “BT Settings”.3 Select the Menu itemTurn the [VOL] knob and press it when thedesired item is displayed.Display Overview“BT Settings”“Phone Selection” Select a cell-phone or Bluetooth audio playerconnection.Refer to Wish to Connect> (page 48).“Audio Selection”“SMS Download” Download a short message.Refer to (page 52).“SMS inbox” Display the received short message.Refer to (page 52).“Voice Tag” Registers voice for voice recognition and voiceto select the Phone number category in Phonebook.- Adding a Voice Dialing Command (page 50)- Setting a Voice Command for Category (page50)“Detailed Setup” Move to detailed item.“Device Regist.” Register a Bluetooth device (pairing).Refer to (page 47).“SPCL DVCSelect”“Device Delete” Cancel registration of the Bluetooth device.Refer to device> (page 49).“PIN Code Edit” Specify the PIN code required when registeringthis unit using the Bluetooth device.Refer to (page 48).“Auto Answer” Answer a call automatically after lapse of thepreset time interval for automatic answer.“OFF”/ “0s” – “8s” – “99s”“Bluetooth HF/Audio”You can specify output speakers for hands-freevoice communication and Bluetooth audiosound.“FRONT”: Outputs voice from the frontspeakers.“ALL”: Outputs voice from the front and rearspeakers.“Call Beep” You can output a beep from the speaker whena call comes in.“ON”: Beep is heard.“OFF”: Beep is canceled.“BT F/W Update” Display the version of the firmware of this unit.“Mic Gain” Adjust the sensitivity of the built-in microphonefor a telephone call. Adjust the voice of caller.Setting to “+” increases the voice volume.“–3” – “0” – “+3”“NR Level” Reduce the noises generated by surroundingenvironment without changing the built-inmicrophone volume. Adjust the voice of callerwhen it is not clear. Setting to “+” increases thenoise reduction.“–3” – “0” – “+3”“Echo Cancel LV“ Adjust the level of echo cancellation. Setting to“+” increases the echo cancel reduction.“–2” – “0” – “+2”( : Factory setting)4 Make a setting• When the “ PUSH ” icon is displayed (at theright edge of the display)Turn the [VOL] knob to select a setting value,and then press the [VOL] knob.• When the “ PUSH ” icon is not displayedPress the [4] or [¢] button to select asetting value.5 Exit BT Settings modeKDC-BT60UPress the [ ] button.KDC-6047UPress the [TI] button for at least 1 second.Remarks• “Auto Answer” (Setting the Time Interval for AutomaticAnswer)This function automatically answers (responds to) a callafter lapse of the preset time interval for automatic answer.“OFF” : Does not answer the phone call automatically.“0” : Automatically answers the phone call at once.“1s” – “99s” : Automatically answers the phone call afterlapse of 1 – 99 seconds.⁄• If the time set in the cell-phone is shorter than that set inFunction of KDC-BT60UKDC-6047U with KCA-BT200 (Optional Accessory)4MENU VOL¢38 / TI
