English | 7Before UsingExit of the Demonstration ModeTurn off the demonstration mode when you use itfor the first time after installation.1 Press the [VOL] knob to quit the demonstrationmode when the messages “To Cancel DemoPress the Volume Knob” are displayed (approx. 15seconds).2 Turn the [VOL] knob to select “YES” and press the[VOL] knob.⁄• Demonstration mode can also be cancelled in “DEMOMode” of Menu List mode. Refer to Setting> (page 35).Common OperationPower and source selectTurns the power ON by pressing the [SRC]button.When the power is ON, select a source.• SRC Select mode 1: Press the [SRC] button andthen turn the [VOL] knob. To determine theselected source, press the [VOL] knob.• SRC Select mode 2: Pressing the [SRC] buttoneach time switches between sources.Tuner (“TUNER”) ➜ Bluetooth Audio (“BTAUDIO”) (KDC-BT60U only) ➜ USB (“USB”)or iPod (“iPod”) ➜ Auxiliary input (“AUX”) ➜Standby (“STANDBY”) ➜ Tuner...Keeping pressing the [SRC] button for at least 1second turns the power OFF.⁄• The SRC Select mode can be set in “SRC Select” of Settings> (page 34).• Auxiliary input source is initially set to “OFF”. Set “Built inAUX” described in (page 34) to “ON”.• When an optional accessory is connected, the source namefor each device appears.• When connection of the iPod is recognized, the sourcedisplay changes from “USB” to “iPod”.• This unit automatically turns full power OFF after 20minutes lapses in Standby mode in order to save thevehicle’s battery. The time until full power OFF can be set in“Power OFF Wait” of (page 34).VolumeTurning the [VOL] knob adjusts the soundvolume.Menu List OperationThe basic operating procedure for using thisfunction is described below. The individual functionitems are covered in the operating procedures.1 Select the sourcePress the [SRC] button. Turn the [VOL] knoband press it when the desired item is displayed.Function items vary from source to source. For a listof the function items. Refer to ✍ SRC Select mode 2: Pressing the [SRC] buttonrepeatedly switches source.2 Enter Menu List modePress the [MENU] button.3 Select the setting itemTurn the [VOL] knob and press it when thedesired item is displayed.Repeat the operation until your desired setup itemis selected.✍ Press the [MENU] button to return to theprevious item.Operation example:MusicPlayListsMy…ArtistsAlbums…Play Mode…[VOL] [MENU][VOL] [MENU]1 122 343 1 32 41 sec.In this manual, the above selection is indicated asSelect “Music” > “Playlists” > “My Best 25”.4 Make a setting• When the “ PUSH ” icon is displayed (at theright edge of the display)Turn the [VOL] knob to select a setting value,and then press the [VOL] knob.• When the “ PUSH ” icon is not displayedPress the [4] or [¢] button to select asetting value.5 Exit Menu List modePress the [MENU] button for at least 1 second toreturn to the first hierarchy. Press the [MENU]button in the first hierarchy to exit the MenuList mode.⁄• You cannot set the item with the “ ” icon displayed.General operation
