Kenwood KDC-7027 Instruction Manual

Also see for KDC-7027: Service manual

34 | EnglishMenu systemContrast AdjustmentAdjusting the display contrast.Display and Setting"Contrast 0"…"Contrast 5" (Original setting)…"Contrast 10"DimmerDimming this unit’s display automatically whenthe vehicle light switch is turned ON.Display Setting"Dimmer ON" The display dims."Dimmer OFF" The display doesn’t dim.OFF Wait Time SettingSetting the time until the faceplate hideoperation starts after the power is turned OFF.The faceplate can be removed only during the settime period.Display and Setting"Off Wait 0s"…"Off Wait 3s" (Original setting)…"Off Wait 25s"In Standby modeEject angle settingThis function sets the opening and closingoperation of a panel when a disc is inserted andwhen it is ejected.Display Setting"EJCT ANG SLP" Opens and closes the panel while maintainingthe angle of the control panel to the set angle."EJCT ANG LVL" Opens and closes the panel after setting theangle of the control panel to the horizontalposition.In Standby modePanel action settingSets the panel movement when the panel action(back/forward movement) is set to its most endposition.Display Setting"PanelCNT 1" No angle can be adjusted if the panel positionhas been set to its most end position. Also, if youhave set the angle below the horizontal position,the angle is set to horizontal when you set thepanel to its most end position."PanelCNT 2" The angle can be adjusted regardless of thepanel position.System Q SettingSetting whether the display indicates the SystemQ factors (Bass center frequency, Bass Q factor,Bass extend, Middle center frequency, MiddleQ factor, and Treble center frequency) in Audiocontrol.Display Setting"SystemQ ON" The System Q factors are displayed."SystemQ OFF" The System Q factors aren’t displayed.In Standby modeSwitching preoutSwitching the preout between the rear andsubwoofer. (In subwoofer it outputs withouteffect from the fader control.)Display Setting"SWPRE Rear" Rear preout."SWPRE Sub-W" Subwoofer preout.