Kenwood KDC-7027 Instruction Manual

Also see for KDC-7027: Service manual

4 | EnglishSafety precautionsNOTE• If you experience problems during installation,consult your Kenwood dealer.• If the unit fails to operate properly, press the Resetbutton. The unit returns to factory settings whenthe Reset button is pressed. If the unit still fails tooperate properly after the Reset button has beenpressed, contact your local KENWOOD dealer forassistance.• Press the reset button if the disc auto changer failsto operate correctly. Normal operation should berestored.• Characters in the LCD may become difficult toread in temperatures below 41 ˚F (5 ˚C).• The illustrations of the display and the panelappearing in this manual are examples used toexplain more clearly how the controls are used.Therefore, what appears on the display in theillustrations may differ from what appears onthe display on the actual equipment, and someof the illustrations on the display may representsomething impossible in actual operation.Lens FoggingRight after you turn on the car heater in coldweather, dew or condensation may form onthe lens in the CD player of the unit. Called lensfogging, CDs may be impossible to play. In sucha situation, remove the disc and wait for thecondensation to evaporate. If the unit still doesnot operate normally after a while, consult yourKenwood dealer.About CD players/disc changersconnected to this unitKENWOOD disc changers/ CD players released in1998 or later can be connected to this unit.Refer to the catalog or consult your Kenwooddealer for connectable models of disc changers/CD players.Note that any KENWOOD disc changers/ CD playersreleased in 1997 or earlier and disc changers madeby other makers cannot be connected to this unit.Unsupported connection may result in damage.Setting the "O-N" Switch to the "N" position for theapplicable KENWOOD disc changers/ CD players.The functions that can be used and the informationthat can be displayed will differ depending on themodels being connected.• You can damage both your unit and the CD changer ifyou connect them incorrectly.LX-bus connectionThe LX AMP and the sensor unit cannot beconnected simultaneously.You must connect any of them at a time.(The power supply does not turn ON if you haveconnected both of them.)Do Not Load 8 cm (3 in.) CDs in the CDslotIf you try to load a 8 cm (3 in.) CD with its adapterinto the unit, the adapter might separate from theCD and damage the unit.Reset button