Kenwood KDC-7090R Instruction Manual

Also see for KDC-7090R: Service manual

Kenwood KDC-7090R Instruction Manual Manual pdf 30 page image

Adjust the time manually.This adjustment is available only when the automatic timeadjustment is set to off. (page 31)Display and setting:Select the display "Clock Adjust" during the selecting functionin the menu system.Hold down either the 4 or ¢ button for one second ormore to enter the Manual time adjustment mode.21NOTEManual Time AdjustmentThis function produces a beep sound that accompanies buttonoperation. It can be switched on or off.Display and setting:"Beep ON" : Beep setting is on. (Default setting)"Beep OFF" : Beep setting is off.The beep sound is not output from the preout jacks.NOTETouch Sensor Toneprocedure in step 4.Hold down the transmit button on the Mask key again until thefull transmit level indicator lights up in the display."APPROVED" will appear in the display, with the Mask keyfunction turning on.If you press the RESET button or remove the battery:The first time you turn the unit on again, "TRANSMIT 1" willappear in the display, indicating the setting mode has beenentered. Repeat steps 4 and 5 above, and transmit the signal.You can start operating the unit again when "APPROVED"appears in the display.5If you have transmitted the Mask Key's signal once to the unitin advance, you will have to transmit it once again if the unithas been removed from the battery. This function helpsprevent theft.When using the unit for the first time:In order to deactivate the demonstration mode, be sure topress the transmit button to transmit the Mask Key's signal.If this procedure is not carried out, the control panel of the unitwill re-open in two seconds even with your vehicle's ignitionturned off.Press the SRC button repeatedly to select the standby mode."ALL OFF" is displayed when the standby mode is selected.Hold down the MENU button for one second or more."MENU" is displayed and "Mask key" appears in the display.Hold down either the 4 or ¢ button for one seconds ormore."TRANSMIT 1" will appear in the display, indicating the settingmode has been entered.Hold down the transmit button on the Mask key until the fulltransmit level indicator lights up in the display."TRANSMIT 2" will be displayed.• Keep the Mask Key close to the signal sensor when youtransmit the Mask Key’s signal.• If the Mask Key’s signal does not be received correctly, thedisplay will return to "TRANSMIT 1" . In this case, repeat theNOTETransmit buttonTransmission part4321Mask KeyMenu settings— 30 —English