Kenwood KDC-BT945U Instruction Manual

Also see for KDC-BT945U: Service manual Quick start guide Instruction manual

Contents

Kenwood KDC-BT945U Instruction Manual Manual pdf 57 page image

English | 57Press the [MENU] button for at least 1 second,and then press it again briefly.⁄• You cannot Channel search until the categoryinformation is acquired.Preset MemoryPutting the channel in the memory.1 Select the channel you wish to store in thepreset memory2 Enter Menu List modePress the [MENU] button.3 Enter Preset Memory modeTurn the [VOL] knob and press it when thedesired item is displayed.Select “List & Memory”.4 Select the number to put in the memoryTurn the [VOL] knob and press [VOL] knob forat least 2 seconds when the desired item isdisplayed.Select preset number.Cancelling the Preset Memory modePress the [MENU] button for at least 1 second,and then press it again briefly.⁄• Only the channel number is stored. Category informationis not stored.Preset TuningRecalling the channels in the memory.1 Select Satellite Radio source2 Enter Menu List modePress the [MENU] button.3 Select a desired station in the memoryTurn the [VOL] knob and press it when thedesired item is displayed.Select “List & Memory” > Preset number.Channel ScanEvery receivable Channel is checked for 10 seconds.1 Select Satellite Radio source2 Enter Menu List modePress the [MENU] button.3 Enter Channel ScanTurn the [VOL] knob and press it when thedesired item is displayed.Select “Channel Scan”.4 Start Channel ScanTurn the [VOL] knob and press it when thedesired item is displayed.Select “YES”.5 Release it when the channel you want to listento is receivedPress the [VOL] knob.Function of remote controlDirect Access TuningEntering the channel and tuning.1 Select Satellite Radio source2 Enter Direct Access Tuning modePress the [DIRECT] button on the remotecontrol.“– – – –” is displayed.3 Enter the channelPress the number buttons.4 Tune in to the entered channelPress the [4] or [¢] button.Cancelling Direct Access TuningPress the [DIRECT] button on the remotecontrol.⁄• If you make no button operation for 10 seconds, theDirect Access Tuning mode is automatically canceled.• If you cannot receive any signal in the input Channel dueto bad conditions on radio wave or other such problems,“Acquiring Signal”/ “No Signal” appears.