12 | KDC-MP6539U/ KDC-MP6039Tuner OperationFunction of remote controlDirect Access TuningEntering the frequency and tuning.1 Enter Direct Access Tuning modePress the [DIRECT] button on the remotecontrol.“– – – –” is displayed.2 Enter the frequencyPress the number buttons on the remotecontrol.Example:Desired frequency Press button92.1 MHz (FM) [0], [9], [2], [1]810 kHz (AM) [0], [8], [1], [0]Cancelling Direct Access TuningPress the [DIRECT] button on the remotecontrol.⁄• You can enter the FM band frequency in steps of aminimum of 0.1 MHz.Frequency Step SettingChanging the tuning frequency step.The original setting is FM band 50 kHz, and AMband 9 kHz.1 Turn the power OFFPress the [SRC] button for at least 1 second.2 Switch the frequency stepWhile pressing the [FNC] and [AUTO] buttons,press the [SRC] button.Release your fingers from the button after thedisplay appears.The frequency step changes to FM band 200 kHz,and AM band 10 kHz.⁄• When the same operation is repeated, the frequencystep returns to the original setting.• When the frequency step is changed, the frequencies inthe memory are deleted.Station Preset MemoryPutting a station in the memory.1 Select the frequency to put in the memoryPush the Control knob towards right or left.2 Enter Preset Memory modeSelect “P.MEM”.For how to select Function Control item, refer to (page 6).3 Select the number to put in the memoryTurn the Control knob.4 Determine the number to put in the memoryPress the Control knob.5 Allow the determined number to take effectPress the Control knob.Cancelling the Preset Memory modePress the [FNC] button.Preset TuningRecalling the stations in the memory.1 Enter Preset Tuning Select modeTurn the Control knob.A station list is displayed.2 Select a desired station in the memoryTurn the Control knob.3 Recall the stationPress the Control knob.Cancelling Preset TuningPress the [FNC] button.