Kenwood KDC-MP6039 Instruction Manual

Also see for KDC-MP6039: Service manual Service manual

26 | KDC-MP6539U/ KDC-MP6039The messages shown below display yoursystems condition.TOC Error: • No disc has been loaded in the discmagazine.• The CD is quite dirty. The CD is upside-down. The CD is scratched a lot.Error 05: The disc is unreadable.Error 77: The unit is malfunctioning for some reason.➪ Press the reset button on the unit. If the“Error 77” code does not disappear, consultyour nearest service center.Mecha Error: Something is wrong with the disc magazine.Or the unit is malfunctioning for some reason.➪ Check the disc magazine. And then pressthe reset button on the unit. If the “MechaError” code does not disappear, consultyour nearest service center.IN (Blink): The CD player section is not operatingproperly.➪ Reinsert the CD. If the CD cannot beejected or the display continues to flasheven when the CD has been properlyreinserted, please switch off the powerand consult your nearest service center.Protect: The speaker wire has a short-circuit ortouches the chassis of the vehicle, and thenthe protection function is activated.➪ Wire or insulate the speaker cable properlyand press the reset button. If the “Protect”code does not disappear, consult yournearest service center.Unsupported File:An Audio file is played with a format that thisunit can’t support.Copy Protect:Copy Protection:A copy-protected file is played.Read Error: The file system of the connected USB deviceis broken.➪ Copy the files and folders for the USBdevice again. If the error message is stilldisplayed, initialize the USB device or useother USB devices.No Device: The USB device is selected as a sourcealthough no USB device is connected.➪ Change the source to any source otherthan USB. Connect an USB device, andchange the source to USB again.N/A Device: An unsupported USB device is connected.No Music Data/ Error 15:• The connected USB device contains noplayable audio file.• Media was played that does not have datarecorded that the unit can play.USB ERROR (Blink):Some trouble may have occurred to theconnected USB device.➪ Remove the USB device, then cycle thepower switch to ON. If the same display isrepeated, use another USB device.iPod Error: Connection to the iPod has failed.➪ Check that the connected iPod is an iPodthat is supported. See (page 20) for information on supportediPods.➪ Remove the USB device and thenreconnect it.➪ Confirm that the software for the iPod isthe latest version.USB REMOVE: The Remove mode has been selected for theUSB device/iPod. You can remove the USBdevice/iPod safely.Troubleshooting Guide

/ 28

Related manuals for Kenwood KDC-MP6039