English | 11 Audio Control 1 Select the source to adjust Press the [SRC] button. 2 Enter Audio Control mode Press the [VOL] knob. 3 Select the Audio item to adjust Press the [VOL] knob. Each time you press the knob, the item to be adjusted alternates between the items shown in the table below. 4 Adjust the Audio item Turn the [VOL] knob. Adjustment Item Display Range Rear Volume * 1 "REAR VOLUME" 0 — 35 Subwoofer level* 2 * 3 "SW LEVEL" –15 — +15 Balance "BALANCE" Left 15 — Right 15 Fader* 3 "FADER" Rear 15 — Front 15 Exit Audio Control mode • * 1 You can control this item when "2ZONE" of Setup> (page 11) is set to "ON". • * 2 You can control this item when Speaker Select Subwoofer of (page 13) is set to any item other than "None". • * 2 You can control this item when Output> (page 12) is set to "SUBWOOFER ON". • * 3 You can control this item when "2ZONE" of Setup> (page 11) is set to "OFF". 5 Exit Audio Control mode Press the [AUTO] or [NEXT] button. Audio Setup Setting the Sound system, such as Volume offset and Dual Zone. 1 Select the source to adjust Press the [SRC] button. 2 Enter Audio Setup mode Press the [VOL] knob for at least 1 second. 3 Select the Audio Setup item to adjust Press the [VOL] knob. Each time you press the knob, the item to be adjusted alternates between the items shown in the table below. 4 Setup the Audio item Turn the [VOL] knob. Adjustment Item Display Range Volume offset "VOLUME OFFSET" –8 — 0 Dual Zone System "2ZONE" ON/OFF • Volume offset: Sets each source’s volume as a difference from the basic volume. • Dual Zone System Main source and sub source (Auxiliary input) output Front channel and Rear channel separately. - Set up the channel of sub source by System Setting> (page 48). - Select Main source by [SRC] button. - Adjust the volume of Front channel by [VOL] knob. - Adjust the volume of Rear channel by Control> (page 11). - The Audio Control has no effect on sub source. • You can use the Dual Zone System with the Auxiliary input sources listed below. - Internal auxiliary input • You can use the Dual Zone System only when you have set the rear speaker to any mode other than "None" in the (page 13). • When the "2ZONE" is ON, ignore the following setups. - (page 12) - (page 13) - (page 14) - (page 15) - (page 16) • ODD D/A System is not effective when the "2ZONE" is ON. 5 Exit Audio Setup mode Press the [VOL] knob for at least 1 second. Previous Next