Kenwood KDC-MP928 Instruction Manual

Also see for KDC-MP928: Service manual

English | 47In Standby modeContrast AdjustmentAdjusting the display contrast.Display and Setting"Contrast: 1"…"Contrast: 4" (Original setting)In Standby modeDisplay-reversing SettingIf no operation is performed for a predeterminedperiod of time, switching between negative andpositive display modes takes place automatically.Display-reversing maintains the initial brightnessof the display for a long period of time.Display Setting"Display N/P: Auto" Auto reverse display"Display N/P: POSI" Positive display only• Switching between negative and positive display maynot take place depending on the displayed mode.In Standby modeBuilt-in Amp SettingControlling the built-in amplifier.Turning OFF this control enhances the preoutquality.Display Setting"AMP: ON" The built-in amplifier activates."AMP: OFF" The built-in amplifier deactivates.In Standby modeG-Counter Level setCalibrating G-Point. Setting the level according tothe kinds of vehicles.Display Setting"G-Counter: Level 1" Counter is easy to go up."G-Counter: Level 2"…"G-Counter: Level 3" Counter is hard to go up.• In the case of driving situations calling for fewaccelerations, set the G-Point up to "G-Counter: Level1". In the case of frequent accelerations, set it up to "G-Counter: Level 3".In Standby modeG-Analyzer ResetResets the value of G-Meter and G-Counter.1 Select G-Analyzer Reset modePush the Control knob towards [4] or[¢].Select the "G-Reset" display.2 Enter G-Analyzer Reset modePress the Control knob for at least 1 second.3 Select the Reset itemPush the Control knob towards [FM] or [AM]."G-Meter Reset": Reset the value of G-Meter."G-Counter Reset": Reset the value of G-Counter.4 Reset the valuePress the Control knob for at least 2 seconds."Reset OK" is displayed.5 Exit G-Analyzer Reset modePress the [MENU] button.