Kenwood KDC-PS909 Instruction Manual

Also see for KDC-PS909: Instruction manual Instruction manual Instruction manual

Kenwood KDC-PS909 Instruction Manual Manual pdf 23 page image

— 23 —Presetting Disc NamesStore the names of discs to be displayed when played.Play the disc whose name you want to preset.• This function is not available for disc changers that do notfeature the Disc Name Preset function.• This procedure is not to be used to store the disc and tracktitles for MDs that you record.Hold down the NAME.S button for two seconds or more."NAME SET" is displayed and the disc name preset mode isentered.The cursor blinks in the position where character input can bemade.Press either the 4 or ¢ button to move the cursor to thedesired position.The 4 button moves the cursor to the left, and the ¢button to the right.You can also move the cursor left or right by pressing the 4or ¢ buttons, respectively, on the remote control.Press the DISC + or DISC – button to display the desiredcharacter.Besides the alphabet (capital letters only) and numerals, youcan choose the following characters: /, + , – , *, =, <, >, [ and ].Direct Alphabet Input (Function of the KCA-R6A : Optional)If the disc changers that were manufactured and sold after 1997are connected, you can directly input letters using thenumber/letter entry buttons on the remote control.Example: Use the following table to enter the name "DANCE".NOTE432NOTE1Continue steps 3 and 4 until all the characters are chosen forthe name.Press the NAME.S button.The disc name is stored and the disc name preset mode iscancelled.If you make no entry in a 10-second period, the name will bestored with the characters input so far.• The number of characters and discs whose names can bestored will differ depending on the disc changer that isconnected. Please see your disc changer manual for details.Up to 12 characters and 100 CDs can be registered with thisunit.• Discs are identified by their total length and number of tracks. Ifanother disc happens to have the same specifications as onethat you have already stored a name for, the name will bedisplayed for it, too.• If you want to change the name of a disc, repeat steps 1 and 2to display the name, and then repeat steps 3 and 4 to input thechanges.• Pressing the reset button erases the disc names stored in thisunit, but does not erase the names stored in a disc changer.NOTE65#3 1“D”1“A” #2#6“N” 2#2 3“C”#3“E” 2Button to press # Times pressedCharacter