Kenwood KDC-U546BT Instruction Manual

Also see for KDC-U546BT: Service manual

18 | KDC-U546BTOther FunctionsClock Adjustment1 Select the sourcePress the [SRC] button.2 Enter Function Setting modePress the [VOL] knob for at least 1 second.“FUNCTION” is displayed.3 Enter Clock adjustment modeTurn the [VOL] knob and press it when thedesired item is displayed.Select “SETTINGS” > “CLOCK” > “CLOCKADJUST”.The hour display blinks4 Adjusting ClockTurn the [VOL] knob to set the hours and pressit when to finish the hour adjusting.The minute display blinks.Turn the [VOL] knob to set the minutes andpress it when to finish the minute adjusting.5 Exit Function Setting modePress the [ ] button for at least 1 second.Demonstration Mode SettingTurning the demonstration mode ON/OFF.1 Enter Function Setting modePress the [VOL] knob for at least 1 second.“FUNCTION” is displayed.2 Select Demonstration modeTurn the [VOL] knob and press it when thedesired item is displayed.Select “DEMO MODE”.3 Set the Demonstration modeTurn the [VOL] knob and press it when thedesired item is displayed.Select “ON” or “OFF”.4 Exit Function Setting modePress the [ ] button for at least 1 second.Initial SettingYou can select following Initial Setting items.1 Select the Standby sourcePress the [SRC] button.Select the “STANDBY” display.2 Enter Function Setting modePress the [VOL] knob for at least 1 second.“FUNCTION” is displayed.3 Select the function itemTurn the [VOL] knob and press it when thedesired item is displayed.Select “INITIAL SET” > Function item.Function item Selectable setting/item“PRESET TYPE” TYPE NORMAL:1 station can be assigned to 1 preset button in eachof 6 bands (FM1, FM2, FM3, MW, SW1 and SW2),i.e., a total of 36 stations (6 stations x 6 bands) canbe preset.TYPE MIX:A total of 6 stations can be assigned to a total of 6preset buttons regardless of band (FM1, FM2, FM3MW, SW1, and SW2). You can recall a preset stationwithout switching between bands.“KEY BEEP” Setting the operation check sound (beep sound)on/off.OFF/ON“TDF ALARM” Informs you by alarm sound about 30 secondsthat you forgot to detach the faceplate when ACCis set to OFF.OFF/ON“BUILT-IN AUX” When this is set to ON, AUX source can be selected.ON1: Outputs the sound of external unit connectedto the AUX terminal when switched to AUXsource.ON2: Activates the attenuator function whenturning on the power with AUX sourceselected. Cancel the attenuator functionby turning the volume knob clockwisewhen listening to the audio of the externalequipment.OFF: Disables the selection of AUX source. Set toOFF when not using the AUX terminal.[SRC] [VOL][ ]Release button