Function Setting OperationThe basic operating procedure for using thisfunction is described below. The individual functionitems are covered in the operating procedures.1 Select the sourcePress the [SRC] button.Function items vary from source to source. For a listof the function items. Refer to (Page 30).2 Enter Function Setting modePress the [VOL] knob for at least 1 second.”FUNCTION” is displayed.3 Select your desired function itemTurn the [VOL] knob and press it when thedesired item is displayed.Repeat the operation until your desired functionitem is selected.⁄Press the [ ] button to return to the previousitem.Example:AUDIO CONTROL[VOL] [VOL]BASS BOOSTSUPREME SET…DETAILED SET…………DISP SELECTSETTINGS In this manual, the above selection is indicated asSelect “AUDIO CONTROL” > “DETAILED SET” >“SUPREME SET”.4 Make a settingTurn the [VOL] knob to select a setting value,and then press the [VOL] knob.5 Exit Function Setting modePress the [ ] button for at least 1 second.Before UsingExit of the Demonstration ModeTurn off the demonstration mode when you use itfor the first time after installation.1 Press the [VOL] knob to quit the demonstrationmode when the messages “CANCEL DEMO” and“PRESS”, “VOLUME KNOB” are displayed (approx.15 seconds).2 Turn the [VOL] knob to select “YES” and press the[VOL] knob.⁄• The demonstration can be set or cancel using (page 18).Common OperationPower and source selectTurns the power ON by pressing the [SRC]button.Pressing [SRC] button each time switchesbetween sources.Tuner (“TUNER”) ➜ USB or iPod (“USB” or “iPod”)➜ CD (“CD”) ➜ Auxiliary input (“AUX”) ➜ Standby(“STANDBY”)Keeping pressing the [SRC] button at least 1second turns the power OFF.⁄• When connection of the iPod is recognized, the sourcedisplay changes from “USB” to “iPod”.• The source “CD” and “iPod” can be selected when eachsource is ready to play.VolumeTurning the [VOL] knob adjusts the soundvolume.General operationEnglish | 5
