Kenwood KDC-X896 Quick Start Manual

Also see for KDC-452U: Quick start guide

Kenwood KDC-X896 Quick Start Manual Manual pdf 47 page image

54 | KDC-X896/ KDC-BT852HD/ KDC-X496/ KDC-452U/ KMR-550U English | 55ContentsBluetooth setupFunction of KDC-X896, KDC-BT852HDBluetooth detail settingYou can configure the initial settings of this unit.1 Enter the Bluetooth modePress the [ ] button.“BT MODE” is displayed.2 Enter the Function setting modePress and hold the Control knob.3 Select the Detailed Settings itemSelect the following items using the Controlknob.“Settings” “Detailed Settings”4 Select a desired Bluetooth detail setting itemTurn the Control knob to select a Bluetoothdetail setting item, and then press the Controlknob.Display Description“Detailed Settings”“Auto Answer” Automatically answers a call after lapse of thepreset time interval.“OFF”: Does not answer the phone callautomatically.“0SEC”: Automatically answers the phonecall at once.“1SEC” – “8SEC” – “99SEC”:Automatically answers the phone call afterlapse of 1 – 99 seconds.“Auto Reconnect” When set to “ON”, starts re-pairing with theregistered Bluetooth device automaticallywhen it becomes unpaired.“ON” / “OFF”“Bluetooth HF/Audio”Specifies the output speakers for hands-freevoice communication and Bluetooth audiosound.“Front” : Outputs sound from the frontspeakers.“All” : Outputs sound from the front and rearspeakers.“Call Beep” Sets whether to output a beep from thespeaker when a call comes in.“ON” : Outputs a beep.“OFF” : Does not output a beep.“MIC Gain” Adjusts the sensitivity of the microphone fortelephone call or adjusts the voice of the caller.“1” – ”20” – “30”“NR Level” Reduces the noise generated by thesurrounding environment without changingthe microphone volume or adjusts the voiceof the caller when it is not clear. Setting toa positive (+) value enhances the noisereduction effect.“-1” – ”0” – “+1”“Echo Cancel Level” Sets the echo cancellation level.“-1” – ”0” – “+1”( : Factory setting)5 Select a Bluetooth detail setting value anddetermine itTurn the Control knob to select desired setting,and then press the Control knob.The previous item is displayed.6 Exit the Function setting modePress and hold the [ ] button.