Kenwood KRC-509S Instruction Manual

Also see for KRC-509S: Service manual

Contents

This function produces a beep sound that accompanies buttonoperation. It can be switched on or off.Display and setting:"Beep ON" : Beep setting is on. (Default setting)"Beep OFF" : Beep setting is off.The beep sound is not output from the preout jacks.NOTETouch Sensor Toneyou to enter the code once again for confirmation. When"CODE" appears in the display, you can start inputting the code.Press the Preset button and input the security code again.Press the DISP button again for at least three seconds."APPROVED" will appear in the display, with the security codefunction turning on. From this point on, if the unit isdisconnected from the battery, the security code must beentered the first time that the unit's power is turned on."ENTER" and "CODE" will appear in the display, asking you toinput the code.If you input an incorrect security code, the code setting modewill be canceled automatically. Follow the steps from 4 to 8above again.If you press the RESET button or remove the battery:The first time you turn the unit on again, "CODE" will appear inthe display, asking you to input the security code.Repeat steps 7 and 8 above, and input the security code.You can start operating the unit again when "APPROVED"appears in the display.If you enter the incorrect code, the power will turn off. Enterthe correct code to turn the unit on.NOTE87code is input. This function helps prevent theft.You must follow steps 1 to 8 to be able to use the Security Codefunction. Turning off the power during the procedure willdeactivate the security code setting.Once the security code function has been activated, “Security”disappears from the MENU system. Note that it will no longer bepossible to cancel this function afterwards.Press the SRC button repeatedly to select the standby mode."ALL OFF" is displayed when the standby mode is selected.Select the four digits to use in your security code.The four-digit security code is very important, as you will need itto turn the unit on again when the code security function is on.Choose the number carefully and do not forget it (write it downand keep it separately in a safe place).Press the MENU button for at least one second."MENU" is displayed first and then “Security” is displayed.Press either the 4 or ¢ button for at least one second."ENTER" will appear in the display for one second, indicatingthe code setting mode has been entered. When "CODE"appears in the display, you can start inputting the code.Press the preset button and enter the security code that youhave selected in step 2.Example: Use "3510" as the security code.Press the DISP button for at least three seconds.The security code will be set."RE-ENTER" will appear in the display for one second, asking6Step Button to press # Timespressed Display1 #1 436#22#3 24 #4 1“3”“5”“1”“0”543NOTE21NOTE— 21 —