68 KRF-V9300D/KRF-V8300D/KRF-V7300DTroubleshootingSymptom Cause RemedyThe video is not output or is disturbed. The video component is not connected properly. Connect it properly by referring to .$ – ªIf the video component is connected to this unit throughHDMI connection, the digital video signal input from theHDMI input terminals is output only at the HDMI monitoroutput terminal.Video signal may not be output depending on theconnecting method and connected components. Refer to the instruction manuals that come with theconnected components.The input of the TV monitor is not set properly. Confirm the input setup of the TV monitor.A non NTSC/PAL video signal is input. Set the video setup of the video player component toNTSC/PAL. Refer to the instruction manual of the videoplayer component.The HDMI video input is set to "Off" in the HDMI setup. Perform the HDMI setup again by referring to input setup –"HDMI Input"–>. ‚PURE AUDIO MODE is set to "ON". If PURE AUDIO MODE is set to "ON",the video circuitry is switched off and only the input HDMIvideo can be output. Set PURE AUDIO MODE to "OFF".yDisplay is turned off. PURE AUDIO MODE is on. While the PURE AUDIO MODE is on, the display is turnedoff. Turn off the PURE AUDIO MODE. yTunerSymptom Cause RemedyRadio stations cannot be received. No antenna is connected. Connect an antenna. •The broadcast band is not set properly. Set the broadcast band properly. YThe frequency of the desired station is not tuned. Tune in the frequency of the desired station. YInterference Noise due to ignition of an automobile. Install the outdoor antenna away from the road.Noise due to interference from an electric appliance. Turn off the power to the appliance.Noise due to a nearby TV set. Install the unit farther away from the TV.Remote control unitSymptom Cause RemedyRemote control operation is not possible. The remote control is not set to the source operationmode you wish to control. Press the appropriate Input Source key to select the sourceyou wish to control.The remote control has not been changed to the operationmode for the Kenwood DVD player you wish to control. Press the [DVD] key to activate the operation mode for thecomponent you want to control before operation.ÁBatteries are exhausted. Replace with new batteries. @The remote control unit is too far away from the mainsystem, controlling angle is too large, or there is anobstacle between this unit and the remote.Operate the remote control unit within the controllablerange. #There is an obstacle between this unit and the remotecontrol unit. Remove the obstacle.Operation is attempted while recording mode is set to on. Some funcions cannot control while the recording modeis set to on. When not recording, set the recording modeto off. PResetting the MicrocomputerResetting the MicrocomputerIf the unit is completely inoperable, the display is not normal or a problem cannot be solved even after checking the list in, it is required to reset the microcomputer in the unit.While holding down [ ] key on the unit, unplug the power cord and plug it back in.• Please note that resetting the microcomputer will clear the contents of the memory and return the unit to the state it was in when it left thefactory.Troubleshooting
