Kenwood KRF-V8030D Instruction Manual

Also see for KRF-V8030D: Remote control manual Service manual Service manual Instruction manual

17OperationsNormal playbackAdjusting the soundAdjusting the toneYou can adjust the sound quality when the receiver is in the stereo mode.1 Press the SOUND key to select the tone mode to be adjusted.• The bass and treble levels are adjustable from -10 to +10 in 2 stepincrements.• The adjustment item is displayed for approximately 8 seconds.2 Use the MULTI CONTROL knob or the 5/∞ keys to adjust thesound quality.BASS: Select this to adjust the low frequency range.(Press the SOUND key once.)TREB: Select this to adjust the high frequency range.(Press the SOUND key twice.)Once-touch low frequency emphasis (bass boost)You can adjust the sound quality when the receiver is in the stereo mode.Press the F.SHIFT key, then press BASS BOOST key.• Press the key once to select the maximum (+10) low frequencyemphasis setting.• This key does not function when the receiver is in the sound quality orambience effects adjustment mode.Switching back to the previous settingPress the BASS BOOST key again.FMAMMHzkHzPRO LOGIC3DOWN MIXDIGITALS.DIRECTMONITORDSPMEMOST.TUNEDAUTO SOUND AUTOLFECS RSLSTI.VOLBCLIP MUTERDS EON PTYTP TA NEWSSWLSP A RSTEREOMuting the soundThe MUTE key lets you mute the sound of the speakers.Press the MUTE key.To cancelPress the MUTE key again so that the “MUTE” indicator goes off.• Muting can also be canceled by adjusting the volume.BlinksSOURCE DIRECT playback (analog sources only)Use this function to pass the source material direct to the amplifier,bypassing any audio processing.To cancelPress the SOURCE DIRECT key.• When you press the LISTEN MODE, SOUND, or SETUP keys, orswitch to another input source, SOURCE DIRECT playback will becanceled.Listening with headphones1 Press the SPEAKERS A or B key so that the speaker indicatorgoes off.Make sure the Speaker indicatorare turned off.2 Connect headphones to the PHONES jack.• If you turn off all of the speakers when in the surround mode, themode is cancelled as well, resulting in stereo playback.• The speakers do not switch off during the 6CH INPUT mode.Select the other input mode.3 Use the VOLUME CONTROL (VOLUME+/-) to adjust the volume.Press the SOURCE DIRECT key again.• If SOURCE DIRECT playback was activated when using a surroundmode, cancelling it reactivates the previous surround mode.LFECS RSLSTI.VOLBCLIPRDS EON PTYTP TA NEWSSWLSP A RMUTEPHONESVOLUME +/–SOUNDMUTESOUNDMULTI CONTROLVOLUME CONTROLSOURCE DIRECTBASS BOOSTPHONESSPEAKERS A/BF.SHIFT5/∞STEREOFMAMMHzkHzPRO LOGIC3DOWN MIXDIGITALMONITORDSPMEMOST.TUNEDAUTO SOUND AUTOS.DIRECTSWRLLFECS RSLSTI.VOLBCLIP MUTERDS EON PTYTP TA NEWSSP A