Kenwood KRF-V8030D Instruction Manual

Also see for KRF-V8030D: Remote control manual Service manual Service manual Instruction manual

31Remote ControlThe remote control supplied with this receiver is alsocapable of controlling components from a variety of manu-facturers once you register the appropriate setup codesinto the remote control unit.Refer to "Remote operation of other components" for de-tails about the operations available for each component.!1How to use the display operation keys Press the display operation 1 key repeatedly until“Menu” appears in the display.Getting the most from your remote control2Press the display operation 2 [Menu] key repeatedly until“01.IR” appears in the display.• At this time all inputs become available regardless of any earlierregistration.Low battery warningReplace all four batteries with new ones when you notice a shorteningof the distance from which the remote control will operate. The remotecontrol is designed to retain setup codes in memory while you changebatteries.For step 1 through step @, make sure you start the next stepwithin 8 seconds of completing the previous one. If more than8 seconds elapses between any two steps, press the displayoperation keys so that the display appears.Registering setup codes for other componentsTo register the setup code, use the display operation 1 key, displayoperation 2 key, or 5/∞ keys.The display operation 1 key and display operation 2 key work as thefunction key displayed in the display above.The display goes off automatically when you do not operate for more than8 seconds. In this case, press the display operation 1 key, displayoperation 2 key, or 5/∞ keys.When the display goes offPress the display operation 1 key repeatedly until “Menu” appears in thedisplay.The display returns to the initial display.When you are confused about what’s being displayedVCRVideo1:Menu• The setup display appears.Press the 5/∞keys to select “01.IR,” then press thedisplay operation 2 [Enter] key.• The input selecting display appears.Press the 5/∞keys to select the input that you want toregister.• Each time you press the 5/∞ key, the input changes as follows:01: CD/DVD02: MD/Tape03: Video104: Video205: Video306: DVD07: TV108: TV209: Cable10: PhonoContinued to next page34>06.Cable>05.VCRBack EnterThe display operation 1 key• [Back]Go back to the previous display.• [Home]Go back to the initial display.• [Clr]Erase the internal memory.The display operation 2 key• [Enter]Enter the selected item.• [Menu]Display the menu.• [Setup]Go to the setup display.• [Exit]Exit from the current operation.• [Sel]Select the item.5/∞Display operation 1Display operation 2Display+–+–5/∞Display operation 1Display operation 2Display+–+–>04.Video2>03.Video1Back Enter>02.Surround>01.IRHome Enter• Example: To select the source connected the VIDEO1 jack, select"Video1".