Kenwood KRF-V8030D Instruction Manual

Also see for KRF-V8030D: Remote control manual Service manual Service manual Instruction manual

37Remote Control6 Press the key of the same operation that you want to store.• The remote code is send to the remote control unit.• "Complete" appears when finished.• When it takes for more than 8 seconds or the remote control unit doesnot receive the remote control code well, "Error" appears in thedisplay. In this case, re-operate from the step 1.• "Full" appears when the memory is full. Re-operate from the step1 after deleting some memories.7 The remote control code is stored on the memory (Extend1 –Extend5) of the remote control unit.To operate other components by using the stored memory2 Press the [Menu] key .• The Menu display appears.3 Press the 5/∞ keys to select the memory you want to operate.4 Press the [Enter] key.To delete the stored memoryPress the [Clr] key in step 5. "Cleared" appears in the displayand the memory that is selected in step 4 is erased.1 Press the MUSIC, MOVIE, or TV key to select desired inputsource.You can restore the setup codes or memories to their original defaultsettings.• "Cleared" appears in the display, and the remote settings return totheir original default settings.Getting the most from your remote control5+–+–TUNINGBANDENTERInsert the batteries during pressing and holding the [5]keys and [ ]key.21Restoring the original factory settings4 Press the 5/∞ keys to select the location.• Extend1 – Extend5 are available.5 Press the [Enter] key.• The remote control is ready for receiving the remote control code.>Extend1WaitingClr Exit>Extend1>Extend1CompleteExtend 1