31 ENAmbience effectsDVD 6-channel playbackUsing a DVD player or the like equipped with six (5.1) output channels andthe receiver, you can enjoy surround sound playback.When you try to play a disc other than Dolby Digital such as DTS CD, nosound is produced or, noise may be heard. To avoid this situation, makesure that you connect the component to the receiver’s DVD/6CH INPUTjacks through a surround processor which can decode the surroundsignal you want to listen to.Connecting a DVD player which can decode the surround signal itself isalso acceptable.INPUT MODEDVD/6CHINPUT MODEVOLUMEDVD/6CHVOLUME /Preparations• Connect your DVD player to the DVD/6CH jacks of the receiver.• Turn on all other components that will be used.• Complete “Preparing for surround sound”. )1Press “DVD/6CH” as the input source.• If speaker system B is on when “DVD/6CH” is selected as the inputsource, it switches off and speaker system A turns on automati-cally.2Select "6CH INPUT" by pressing the INPUT MODE key.3Start playback of the DVD software.4Adjust the volume.• It is not possible to adjust the volume level or sound quality (SETUP, SOUND) of the channels separately when the receiver is in theDVD/6CH mode. Adjust the volume with the controls of the DVDplayer.For the powered subwoofer, you can adjust the volume of thesubwoofer using the subwoofer’s own volume control.3DSP mode (Digital Signal Processor).DSP can produce these effects without spoiling the sound quality ofthe original music or video source.1 Pressing the DSP key or DSP MODE key will display thecurrent DSP MODE status.2 Each press of the key will switch to the next status as shownbellow:1 ARENA : DSP surround ARENA mode.2 JAZZ CLUB : DSP surround JAZZ CLUB mode.3 THEATER : DSP surround THEATER mode.4 STADIUM : DSP surround STADIUM mode.5 DISCO : DSP surround DISCO mode.• The DSP mode selection is displayed for approximately 3 seconds.• For fine adjustment of the DSP effects, please refer to “Adjustingthe sound”. ¤4Adjust the volume.Notes• Depending on the type of the signal or speaker setting, some listeningmodes cannot be selected.• When playback is started, the sound may be cut or interrupted beforethe input source is confirmed as Dolby Digital.• To enjoy Dolby Digital surround (as well as all the other listening modes)from a single component, be sure to use a Dolby Digital compatiblesource component.