Kenwood NX-200 Service Manual

Also see for NEXEDGE NX-200: Brochure Instruction manual Instruction manual Specifications Instruction manual

NX-200(G)10DISASSEMBLY FOR REPAIR■ Removing the lithium cell (W09-0971-05)Insert a non-conductive screwdriver to groove of one sideof the socket (CN401,CN11) and pry the lithium cell upfrom the socket.■ Installing the lithium cell (W09-0971-05)Insert a lithium cell into one side of the socket (CN401,CN11).Push the lithium cell to insert the lithium cell into thesocket.■Affixing the keyboard ASSY (S79-0472-05)Affi x the keyboard ASSY to the Control unit as shown inthe figure.After affixing the keyboard ASSY to the Control unit,confirm that the three positioning holes of the keyboardASSY and the Control unit are not misaligned.Note:If the holder (Option board) is removed from the Controlunit, it becomes easy to confirm the three positioningholes.Positioning holes Control unitKeyboardASSY■ Inserting the Volume and Channel switch intothe chassisInsert the volume and channel switch into the chassiswith the VOL/CH FPC formed as shown in the fi gure.VOL/CH FPCVolumeChannel switch■ Forming the VOL/CH FPC, Cord ASSY and Universalconnector FPCForm the VOL/CH FPC, Cord ASSY and Universal con-nector FPC as shown in the figure.VOL/CH FPCUniverConneCord ASSYNote:The illustration of the Sub (GPS) unit and GPScoaxial cable is omitted.Note:Fold indications are printed on the Cord ASSY and Uni-versal Connector FPC.“––––” line shows creased line on the top.“- - - -” line shows creased line on the bottom.CONTTX-RXJ87-0005J87-0007Cord ASSYUniversal Connector FPC■