NX-200(G)64. Power ON the target transceiver.5. Connect the cloning cable (part No. E30-3325-05) to theuniversal connectors on the source and target.6. Press the [ ] key on the source while the source displays“CLONE MODE”. The data of the source is sent to thetarget. While the target is receiving the data, “PROGRAM”is displayed. When cloning of data is completed, thesource displays “END”, and the target automatically oper-ates in the User mode. The target can then be operatedby the same program as the source.7. The other target can be continuously cloned. When the[ ] key on the source is pressed while the source displays“END”, the source displays “CLONE MODE”. Carry outthe operation in step 4 to 6.Note:• Cannot be cloned if the password (overwrite password) isprogrammed to the target.• “Model Name” must be same to clone the transceiver.REALIGNMENTCloning cable(E30-3325-05)12ABC47GHI3DEFMIC12ABC47GHI3DEFMICFig. 28. Firmware Version InformationPress and hold the [Side1] key while turning the trans-ceiver power ON and then keep pressing and holding the[Side1] key, the fi rmware version information appears on theLCD.INSTALLATIONPreparation before Installing Option board■ Removing the GPS PCB1. Remove the two screws from the cover.2. Remove the cover by inserting the tip of a pair of twee-zers into the screw hole of the cover and prying it open.