Kenwood NX-700 Instruction Manual

Also see for NEXEDGE NX-800 series: Brochure Function reference Instruction manual Instruction manual Specifications

Kenwood NX-700 Instruction Manual Manual pdf 26 page image

18■ Identification CodesAn ID code is a combination of a 3-digit Fleet number and a 4-digit ID number.Each transceiver must have its own Fleet and ID number.• Enter a Fleet number (100 ~ 349) to make a group call.• Enter an ID number (1000 ~ 4999) to make an individual call in your fl eet.• Enter a Fleet number to make a call to all units in the selected fl eet (Fleet call).• Enter an ID number to make a call to the selected ID in all fl eets (Supervisor call).• Select “ALL” Fleet and “ALL” ID to make a call to all units (Broadcast call).Note:◆ Broadcast and Supervisor calls are programmed functions that cannot be made with a keypad.◆ The ID range may be limited by programming.STATUS MESSAGEYou can send and receive 2-digit Status messages which may be decided in yourtalk group. Messages can contain up to 16 alphanumeric characters. Statusmessages range from 10 to 99 (80 ~ 99 are reserved for special messages).A maximum of 15 received messages can be stored in the stack memory of yourtransceiver. These saved messages can be reviewed after reception. Dependingon your dealer settings, when the stack memory is full, either the oldest messagewill be erased when a new message is received or the new message will not bestored in the stack memory. The icon lights when a message is stored in thestack memory.■ Transmitting1 Select your desired zone and channel.2 Press the key programmed as Status to enter Status mode or Selcall +Status to enter Selcall mode.• When using the Status key to enter Status mode, the target Fleet/ ID is fi xed andcannot be selected. Skip to step 5 to continue.3 In Selcall mode, press the / keys to select the ID of the station you wantto call.• If Manual Dialing is enabled, you can enter the station ID by using themicrophone keypad, or by using the / keys. When using the / keys,cycle through the digits to select a digit, then press the key to setthe digit and move the cursor to the right. Repeat this process until theentire ID is entered.4 Press the key enter Status mode.5 Press the / keys to select the status ID you want to transmit.• If Manual Dialing is enabled, you can enter the station ID by using themicrophone keypad, or by using the / keys. When using the / keys,cycle through the digits to select a digit, then press the key to setthe digit and move the cursor to the right. Repeat this process until theentire ID is entered.