SCAN – 2VFO SCANVFO Scan monitors all frequencies tunable on the band,using the current frequency step size.1 Select your desired band.2 Press [VFO] (1s).• Scan starts at the current frequency.• The 1 MHz decimal point blinks while scanning is inprogress.• To reverse the scan direction, turn the Tuningcontrol clockwise ]> (upward scan) orcounterclockwise ]> (downward scan).3 To quit VFO Scan, press [VFO] again.MEMORY SCANUse Memory Scan to monitor all Memory channelsprogrammed with frequency data.1 Select your desired band.2 Press [MR] (1s).• Scan starts at the current memory channel.• The 1 MHz decimal point blinks while scanning is inprogress.• To reverse the scan direction, turn the Tuningcontrol clockwise ]> (upward scan) orcounterclockwise ]> (downward scan).3 To quit Memory Scan, press [MR] again.Note:X At least 2 Memory channels must contain data and must not belocked out of scan.X The L0/U0 to L9/U9 Memory channels will not be scanned.X You can also start Memory Scan when in Channel Display mode.While Scan is paused on a channel, the channel number blinks.Q Locking Out a Memory ChannelYou can select Memory channels that you prefer not tomonitor while scanning.1 Press [MR], then rotate the Tuning control to selectyour desired channel.2 Enter Menu mode and access Menu 142.3 Set the lockout to “On” to lock the channel out of thescanning sequence.• To cancel lockout, set the lockout to “Off”.• The “ ” icon appears on the display for a channel thathas been locked out.Note: The L0/U0 to L9/U9 Memory channels cannot be lockedout.GROUP SCANFor the purpose of Group Scan, the 1000 Memorychannels are divided into 10 groups, with each groupcontaining 100 channels. Group Scan monitors only the100 channels which belong to the specific group you arescanning. The channels are grouped as follows:MemoryGroupChannelRangeMemoryGroupChannelRange0 0 ~ 99 5 500 ~ 5991 100 ~ 199 6 600 ~ 6992 200 ~ 299 7 700 ~ 7993 300 ~ 399 8 800 ~ 8994 400 ~ 499 9 900 ~ 9991 Press [MR], then press [ ]/[ ] or rotate the Tuningcontrol to select a channel in your desired group.2 Press [MHz] (1s).• Scan starts at the current channel.• The 1 MHz decimal point blinks while scanning is inprogress.• To reverse the scan direction, turn the Tuningcontrol clockwise ]> (upward scan) orcounterclockwise ]> (downward scan).3 To quit Group Scan, press [MHz] again.Note:X At least 2 Memory channels in the selected group must containdata and must not be locked out of scan.X You can also start Memory Scan when in Channel Display mode.While Scan is paused on a channel, the channel number blinks.