Kenwood TH-D72A Instruction Manual

Also see for TH-D72A: User manual Instruction manual Instruction manual Instruction manual Service manual

Contents

SCAN – 3Q Naming a Memory GroupYou can name Memory group using up to 8 characters.1 Press [MHz], then press [ ]/[ ] or rotate theTuning control to select a channel in your desiredgroup.2 Enter Menu mode and access Menu 144.3 Enter your desired name for the group.Group name display (in MR mode)1 Press [LAMP].• The group name is displayed.2 While pressing [LAMP] rotate the Tuning Control tochange the group.• Rotate the Tuning control clockwise and release[LAMP] to select the smallest memory channel of thenew group.• Rotate the Tuning control counter-clockwise andrelease [LAMP] to select the largest memory channelof the new group.Q Memory Group LinkMemory Group Link provides you with the ability tolink 2 or more Memory channel groups together to actas a single group when scanning. You can link upto 10 separate groups together, or even add multipleinstances of the same group to the group link, toensure that one group is scanned more often than theothers.1 Enter Menu mode and access Menu 145.2 Press [ OK].• The cursor will begin blinking.3 Press [ ]/[ ] or rotate the Tuning control to selecta group to link.4 Press [ OK] to set the group and move the cursorto the right.• Press [ESC ] to move the cursor back or [ OK] tomove the cursor to the right.5 Repeat steps 3 and 4 to link additional groupstogether.6 When you have entered your desired groups, press[ OK] to move the cursor to the right, then pressthe Tuning control to complete the entry and exitMenu mode.• You can delete the selected character by pressing[A/B].• If you have entered the maximum of 10 groups, simplypress [ OK] to complete the entry and exit Menumode.Q Clearing a Memory Group1 Press [MR] to enter Memory Recall mode.2 Turn the transceiver power Off.3 Press [MHz] + Power ON to enter Group Clearmode.4 Press [ ]/[ ] or rotate the Tuning control to selectyour desired Group.5 Press [ OK].• “Sure?” appears on the display and blinks.6 Press [ OK] or [MR] to clear the Group.• Repeat steps 4 to 6 to clear additional Group.• To exit without clearing the channel, press [ESC ].