19FleetSync: ALPHANUMERIC 2-WAY PAGING FUNCTIONFleetSync is an Alphanumeric 2-way Paging Function and is a protocol owned byKENWOOD Corporation. FleetSync enables a variety of paging functions onyour transceiver, some of which depend on dealer programming.The TK-7162/ TK-8162 only has access to the PTT ID function of the FleetSyncfeature.Note: Your transceiver functions include either FleetSync or 5-tone Signaling {page 22}, but not both.SELCALL (SELECTIVE C ALLING)A Selcall is a voice call to a particular station or to a group of stations.■ Transmitting (TK-7160/ TK-8160 Only)1 Select your desired zone and channel.2 Press the key programmed as Selcall or Selcall + Status to enter Selcallmode.3 Press the and C> keys to select the ID of the station you want to call,or enter a station ID using a DTMF keypad.• If Manual Input mode is enabled, you can enter digits by using a DTMF keypad.To enter Manual Input mode, first press and hold the S or DTMF key.4 Press the microphone PTT switch and begin your conversation.■ ReceivingThe calling station’s ID will appear (TK-7160/ TK-8160) and an alert tone willsound when a Selcall is received.To respond to the call, press the PTT switch and speak into the microphone.■ Identification CodesAn ID code is a combination of a 3-digit Fleet number and a 4-digit IDnumber. Each transceiver must have its own Fleet and ID number.• Enter a Fleet number (100 ~ 349) to make a group call.• Enter an ID number (1000 ~ 4999) to make an individual call in your fleet.• Enter a Fleet number to make a call to all units in the selected fleet (Interfleet call).• Enter an ID number to make a call to the selected ID in all fleets (Supervisor call).• Select “ALL” Fleet and “ALL” ID to make a call to all units (Broadcast call).Note: The ID range may be limited by programming.