19CONVENTIONAL SCANIf the Scan function is programmed, Conventional zones orchannels can be scanned by pressing the key programmed asScan. Scan can be used as either Single Scan or Multi Scan.• Single Scan monitors only the channels of the currently selectedzone, which have been added to the scanning sequence. If setup to scan Priority channels, the Priority channels will be scannedeven if they are not within the currently selected zone.• Multi Scan monitors all channels of every zone, which have beenadded to the scanning sequence.To activate Scan, press the key programmed as Scan.• The icon and “ ” or the revert zone and channel numberappear on the display.• The zone add indicator ( ) will appear on thedisplay when the selected zone is added to the scan sequence.The channel add indicator ( ) will appear on thedisplay when the selected channel is added to the scansequence.• When a call is received, scanning stops and the zone andchannel digits appear. Press the PTT switch and speak into themicrophone to respond to the call. The transceiver will continuescanning after a predetermined time delay if the PTT switch isreleased and no further signal is received.To stop scanning, press the Scan key again.ADD TO S CAN/ DELETE FROM S CANPress the key programmed as Scan Delete/Add to add orremove each channel to or from the scan sequence.• The channel add indicator ( ) will appear on thedisplay when the selected channel is added to the scansequence.Press the key programmed as Zone Delete/Add to add orremove each zone to or from the scan sequence.• The zone add indicator ( ) will appear on thedisplay when the selected zone is added to the scan sequence.