Kenwood TK-2312 Service Manual

Also see for TK-2317: Specification Instruction manual Instruction manual Service manual

TK-2312/231710DISASSEMBLY FOR REPAIR5. Attaching the Battery Release Lever tothe Case Assembly1. Insert one side of the shaft into the hole at the lever fit-ting section on the case assembly q.Caution: The thin spring (G01-4543-04) should be posi-tioned above the two tabs of the lever.2. Tilt the battery release lever slightly forward w, so thatthe thick spring (G01-4542-04) is positioned below thecase surface.3. With the thick spring positioned below the case surface,attach the other side of the shaft to the case assemblyby pressing the battery release lever e until it snaps intoplace r.Caution: Be careful not to tilt the battery release levertoo forward.If the battery release lever is pushed in this state wherethe two tabs come below the case surface, there is apossibility of damaging the two tabs.A thin springShaftTow tabsA thick spring: @.;6. Assembling the Battery Release Lever1. Place the lever w onto the stopper q.2. Place the thick spring e onto the lever.3. Hook the right and left ends of the thin spring r ontothe tabs of the stopper, then place the thin spring ontothe lever t.4. Slide the shaft through the hole of the stopper and levery.:@.;=B7. Attaching the Positive Terminal to theChassisAlways attach the positive terminal to the chassis, usingthe following procedures, before mounting the TX-RXunit onto the chassis.1. Remove the holder assembly w from the packing q ofthe positive terminal.2. Mount the packing of the positive terminal into the chas-sis hole e.3. Mount the holder assembly into the packing of the posi-tive terminal r.:.;@