Kenwood TK-2312 Service Manual

Also see for TK-2317: Specification Instruction manual Instruction manual Service manual

TK-2312/231743. PC Mode3-1. PrefaceThe transceiver is programmed by using a personal com-puter, a programming interface (KPG-22/22A, USB adapter(KCT-53U)) and FPU (programming software).The programming software can be used with a PC. Fig-ure 1 shows the setup of a PC for programming.3-2. Connection Procedure1. Connect the transceiver to the personal computer withthe interface cable and USB adapter (when the interfacecable is KPG-22A, the KCT-53U can be used).Note:• You must install the KCT-53U driver in the computer touse the USB adapter (KCT-53U).• When using the USB adapter (KCT-53U) for the first time,plug the KCT-53U into a USB port on the computer withthe computer power ON.2. When the POWER is switched on, user mode can be en-tered immediately. When the PC sends a command, thetransceiver enters PC mode.When data is read from the transceiver, the red LEDlights.When data is written to by the transceiver, the greenLED lights.Note:• The data stored in the personal computer must matchModel Name and Model Type when it is written into EE-PROM.• Do not press the [PTT] key during data transmission orreception.3-3. KPG-22/KPG-22A Description(PC programming interface cable: Option)The KPG-22/22A is required to interface the transceiverwith the computer. It has a circuit in its D-sub connector(KPG-22: 25-pin, KPG-22A: 9-pin) case that converts the RS-232C logic level to the TTL level.The KPG-22/22A connects the SP/MIC connector of thetransceiver to the RS-232C serial port of the computer.3-4. KCT-53U Description (USB adapter: Option)The KCT-53U is a cable which connects the KPG-22A toa USB port on a computer.When using the KCT-53U, install the supplied CD-ROM(with driver software) in the computer. The KCT-53U driverruns under Windows 2000, XP or Vista (32-bit).3-5. FPU (Programming Software) DescriptionThe FPU is the programming software for the transceiversupplied on a CD-ROM. This software runs under windowsXP, Vista or 7 on a PC. The software on this disk allows auser to program the transceiver transceivers via Program-ming interface cable (KPG-22/22A).3-6. Programming with PCIf data is transferred to the transceiver from a PC withthe FPU, the data for each set can be modified.Data can be programmed into the EEPROM in RS-232Cformat via the SP/MIC jack.In this mode the PTT line operate as TXD and RXD datalines respectively.List of FPU for transceiverModel Type FPUTK-2312 K, P KPG-134D (K)TK-2312 M KPG-134D (M)TK-2317 MD-SUB(25-pin)Transceiver Transceiver TransceiverKPG-22PCD-SUB(9-pin)KPG-22APCUSBKPG-22AKCT-53UPCPC KPG-22 or KPG-22A orKPG-22A+KCT-53UIllustration is KPG-22.FPU(KPG-134D)Tuning cable(E30-3216-05)GrayGray/Black1.5D-XV Lead wire1.5D-XV Shield wire+–+–SPMICFig. 1REALIGNMENT