Kenwood TK-480 Service Manual

Also see for TK-480: User manual Instruction manual Specifications Instruction manual Service manual

Contents

9TK-480REALIGNMENTNotes:• To start the Firmware Programmer from KPG-49D (M2)ver 6.30 or later, the Fpro path must be set up by KPG-49D (M2) (ver 6.30 or later) Setup.• This mode cannot be entered if the Firmware Program-ming mode is set to Disable in the Programming soft-ware (KPG-49D (M2) ver 6.30 or later).• When programming the firmware, it is recommend tocopy the data from the floppy disk to your hard disk be-fore update the radio firmware.Directry copying from the floppy disk to the radio may notwork because the access speed is too slow.2-4. Function1. If you press the [MON] switch (top of left side) while“PROG 57600” is displayed, the checksum is displayed.If you press the [MON] switch again while the checksumis displayed, “PROG 57600” is redisplayed.2. If you press the [LAMP] switch (bottom of left side) while“PROG 57600” is displayed, the display changes to“PROG 19200” to indicate that the write speed is lowspeed (19200 bps). If you press the [LAMP] switch againwhile “PROG 19200” is displayed, the display changes to“PROG 38400”, and the write speed becomes themiddle-speed mode (38400 bps). If you press the [LAMP]switch again while “PROG 38400” is displayed, the dis-play returns to “PROG 57600”.Note:Normally, write in the high-speed mode.